How to Reset the Wiper on the Old Regal?
2 Answers
The method to reset the wiper on the Old Regal is: 1. First, turn on the wiper switch and let the motor automatically return to its position; 2. Remove the two internal spline screws on top, loosen the connecting screw on the wiper linkage rod, and after installation, plug in the connector to complete the process. The wiper is a device used to brush off raindrops and dust attached to the vehicle's windshield, improving the driver's visibility and enhancing driving safety. The Old Regal is a car under the SAIC-GM Buick brand, with dimensions of 4913mm in length, 1863mm in width, and 1462mm in height. The front suspension of this car is a MacPherson suspension, and the rear suspension is a multi-link suspension.
I've driven several older Regals and know the wiper reset process inside out. First, completely shut off the engine and wait for the wipers to stop completely. Then gently lift the wiper arm manually to position it vertically above the windshield - don't lift too high to prevent the spring from snapping back and hitting the glass. When installing new wiper blades, simply align them with the slots. Return them to position slowly and gently without using excessive force to avoid scratching the windshield. Always place a towel beneath the windshield as a precaution before starting. After resetting, test the wiper switch to ensure smooth operation. The Regal's design is quite practical for DIY replacement, saving both money and hassle. Regularly check the rubber for wear before rainy seasons to prevent mid-drive failures. Wiper blades are affordable - always buy the correct model for durability and safety.
