How to reset the trip meter of Baojun 530?

[DaniellaLynn]

The instrument panel has a protruding small round button. Press and hold this button for a while to reset the meter. Below are the relevant methods to reset the trip meter of Baojun 530: 1. Switch the display interface, which can show five tab interfaces: driving information, fault information & settings, multimedia information, Bluetooth phone information and navigation information. Use the up/down selection keys to switch between options under each tab. The confirmation key is used to confirm the settings. Under the trip mileage interface, long press this button to reset the trip mileage and average fuel consumption. 2. Remove the instrument panel, take off the instrument cover, and remove the pointers for speed, fuel gauge, water temperature, and RPM. Then use a flat-head screwdriver to adjust the mileage gear, which can roll back or reset the mileage.

[ArthurAnn]

When I used to drive the Baojun 530, I often needed to reset the small trip meter when it reached its limit—it's actually super easy! It's that little counter on the dashboard that shows short-distance mileage. After getting in the car but before starting the engine, or when parked, there's a button labeled "TRIP" at the bottom right of the dashboard. First, press it once to switch to the trip meter display, then hold it down firmly for a few seconds until the numbers flash or reset. I often use it to calculate fuel consumption per tank—for example, reset it after filling up, then check the mileage after driving to see how economical it is. Resetting it to record a new trip is quite handy, but remember not to do it while driving—it's unsafe. It's best to do it when parked or before starting the car. If the car doesn’t respond, the button might be stuck or there could be a minor electrical issue—check the manual or visit a repair shop instead of forcing it and risking damage.

[DiBrielle]

I've tried resetting the odometer on the Baojun 530 several times, so here's my experience. There's a dedicated small button on the side or front of the dashboard for this purpose. Turn on the power without pressing the accelerator, switch to TRIP mode, then gently press and hold the button for about five to six seconds until the display flashes or resets directly. I make it a habit to reset it before each trip, which makes it easy to calculate the one-way distance and estimate arrival time in combination with navigation. During regular car maintenance, I also pay attention to cleaning dust off the button to prevent dirt from affecting its sensitivity. If the operation fails, don't worry—it's usually due to poor button contact; try tapping it lightly a few times or restarting the ignition switch and trying again. This feature is quite user-friendly for beginners, designed with human factors in mind, unlike older cars which can be more troublesome.

[PhoebeRose]

Resetting the trip meter on the Baojun 530 is simple: After parking, locate the dashboard button, press TRIP to switch to the trip display, then hold for over 3 seconds to reset. I often use it to track mileage after refueling, making fuel cost calculations effortless. Just avoid pressing the button too hard during daily use.