How to reset the tire pressure warning on the Roewe 360?
3 Answers
The method to reset the tire pressure warning on the Roewe 360 is: 1. Operate the buttons on the multifunction steering wheel and store the tire pressure status through the "Tire Pressure" option in the multifunction menu; 2. There is a tire pressure reset switch on the side of the gear lever. With the ignition switch turned on, press and hold this switch button until you hear a beep to complete the reset. The Roewe 360 is a compact 4-door, 5-seater sedan under SAIC Motor, with dimensions of 4579mm in length, 1804mm in width, and 1490mm in height, a wheelbase of 2660mm, a top speed of 180 km/h, and equipped with a 5-speed manual transmission.
As a seasoned driver who frequently operates the Roewe 360, I've encountered the tire pressure warning a few times. This alert is typically triggered by either insufficient or excessive tire pressure. The steps to reset it are quite straightforward: First, find a safe place to park, then use a tire pressure gauge to check the pressure of all four tires. The standard values can be found on a label near the driver's door frame or in the owner's manual. If the pressure is too low, use a pump to add some air; if it's too high, release some air. After adjusting, return to the car, start the engine but don't drive, and operate the dashboard—press the button on the left side of the steering wheel to switch to the settings menu, select the tire pressure option, and confirm the reset. In most cases, the warning will disappear. Remember to develop a habit of checking tire pressure monthly to avoid sudden issues affecting safety on the road. If the warning light remains on, it might be due to a sensor malfunction or a leak, so it's best to visit a 4S shop for repairs without delay. Overall, this isn't complicated, and handling it yourself saves time and money.
Every time the tire pressure alarm goes off in my Roewe 360, I feel the need to handle it carefully. The method to reset it starts with the basics: first, confirm there are no obvious leaks or punctures in the tires, park the car on level ground, and manually check if each tire looks normal. Then, use a tire pressure gauge to measure the pressure; the standard value is usually around 2.3-2.5 bar—check the manual to be sure. If the pressure is low, go to a gas station to inflate the tires. After adjusting, start the car, find the trip computer settings on the dashboard, select the tire pressure monitoring option, and press the reset button to recalibrate the system. Newer models might have an accompanying app for easier operation. Take your time during the process—safety comes first. If the alarm persists, it could be a sensor or wiring issue, in which case visiting a professional shop is the safest option. Remember, avoiding rough roads can help prevent frequent alarms.
