How to Reset the Tire Pressure on a Geely Emgrand?
3 Answers
Geely Emgrand tire pressure reset method is as follows: 1. Adjust the tire pressure to the normal value; 2. Press and hold the tire pressure reset button for 3 seconds to complete the reset. The Geely Emgrand is a compact 4-door, 5-seater sedan with body dimensions of 4632mm in length, 1789mm in width, 1470mm in height, and a wheelbase of 2650mm. Additional details are as follows: 1. The Geely Emgrand is equipped with a 1.5L naturally aspirated engine and a 5-speed manual transmission, delivering a maximum power of 80 kW and a maximum torque of 142 Nm. 2. It features front-wheel drive, with a MacPherson strut independent front suspension and a torsion beam non-independent rear suspension.
I've been driving my Geely Emgrand for over two years and I'm very familiar with the tire pressure reset procedure. First, power on the vehicle without starting the engine, then locate the menu button on the right side of the steering wheel - it's the one with three horizontal lines. After pressing it, the settings interface will appear on the instrument cluster. Use the volume keys to scroll down to 'Vehicle Settings', confirm entry, then select the 'Tire' option. At this point, you'll see the 'Tire Pressure Reset' prompt - press and hold the OK button for three seconds. After successful reset, drive for about 15 minutes for the system to automatically calibrate. Important reminder: Before operation, make sure all four tires are adjusted to the standard pressure of around 2.4 bar. Last time I didn't notice one tire was leaking, and the alarm kept going off after reset. If the reset fails, there might be a sensor issue requiring a 4S shop inspection.
Regarding the tire pressure reset for the Emgrand, I must remind you to follow the standardized steps. First, ensure the vehicle is in the power-on state, then use the toggle button on the left side of the steering wheel to bring up the main menu on the instrument panel and locate the tire pressure monitoring system in the settings. After clicking to enter, select the reset option, at which point a confirmation tone will sound to verify the operation. Upon completing the reset, you need to drive at a speed of 20-40 km/h for about 10 minutes to allow the system to reacquire data. From personal experience, it's best to perform this on a straight road to avoid turns affecting the calibration. If the tire pressure light remains on after reset, first check if there are any nails in the tires. If you really can't figure it out, don't force it—seeking professional repair service is the more reliable approach.
