How to reset the tire pressure monitoring system on the CRV?
2 Answers
Methods to reset the tire pressure monitoring system on the CRV: 1. Press the arrow button on the lower right side of the steering wheel until the central display shows the personalized settings; 2. Press the sel/reset button to enter the tire pressure monitoring system calibration; 3. Press sel/reset again to set the tire pressure monitoring system calibration; 4. Press the arrow button on the lower right side of the steering wheel to display calibration 2 of 2, then press sel/reset to start the calibration. The system will reset after a few seconds. The CRV is a compact SUV under Dongfeng Honda, with dimensions of 4621mm in length, 1855mm in width, and 1679mm in height, and a wheelbase of 2661mm. In terms of power, the CRV is equipped with a turbocharged engine that delivers a maximum horsepower of 193 hp and a maximum torque of 243 Nm.
Last time I drove my CRV, the tire pressure warning light came on, but resetting it was quite simple. First, make sure the tires are inflated to the standard pressure, which can be found in the owner's manual or on the driver's side door frame. Then, start the engine and locate the tire pressure reset button with an exclamation mark on the left side of the steering wheel. Press and hold it for about 3 seconds until the hazard lights flash and you hear a beep, then release. The system will automatically calibrate, requiring you to drive at a steady speed of 40 km/h for about 15 minutes. Be careful not to brake or turn sharply during calibration, as this can affect the sensor's recognition. Once calibration is successful, the small exclamation light will turn off, and the system will automatically alert you if there's any abnormal tire pressure while driving. Regularly checking tire condition is important, as insufficient tire pressure can increase fuel consumption and accelerate wear.
