How to reset the tire pressure monitoring system on CRV?

1 Answers
DeJason
07/29/25 4:22pm
Method to reset the tire pressure monitoring system on CRV: Press the arrow button on the right side of the steering wheel, wait until the personalized settings screen appears on the central display, then press the sel/reset button. The display will show the interface for entering the tire pressure monitoring system calibration. Follow the steps provided to reset the tire pressure monitoring. The Honda CRV is a classic urban SUV model produced by Dongfeng Honda Automobile Company, with body dimensions of 4550mm in length, 1820mm in width, and 1685mm in height, and a wheelbase of 2620mm. The CRV is equipped with SRS dual airbags, door beams, front and rear 3-point ELR seat belts, seat belt reminders, and seat safety systems with pre-tensioners and load limiters.
Was this review help?
8
3
Share
More Forum Discussions

Where is the windshield wiper?

The windshield wiper is located on the right side of the steering wheel. Pushing it upwards once activates intermittent wiping, and the speed increases the further you push it up. Pulling it all the way down stops the wiper. Below is an introduction to car windshield wipers: 1. Structure of the wiper: The wiper assembly includes components such as a motor, reducer, four-bar linkage, wiper arm spindle, and wiper blade assembly. When the driver presses the wiper switch, the motor starts, and its rotational speed is increased in torque through a worm gear mechanism to drive the swing arm. The swing arm then drives the four-bar linkage, which in turn causes the shaft mounted on the front bulkhead to swing left and right. Finally, the shaft drives the wiper blade to sweep across the windshield. 2. Features of the wiper: It is heat-resistant, cold-resistant, acid and alkali-resistant, corrosion-resistant, fits the windshield well, reduces motor load with low noise, has strong water-repellent properties, and is soft enough not to scratch the windshield.
2
0
Share

Where is the oil dipstick located on the Audi A4L?

Audi A4L's oil dipstick is located next to the engine. The specific steps to check the oil level are: 1. Open the driver's side door; 2. Pull the hood release lever located in the driver's footwell; 3. Lift the front engine hood upwards; 4. Pull out the oil level dipstick located near the engine; 5. The oil level should be between the upper and lower marks on the dipstick. The Audi A4L is a mid-size sedan under FAW-Volkswagen Audi, with body dimensions of 4858mm in length, 1847mm in width, 1439mm in height, a wheelbase of 2908mm, and a minimum ground clearance of 118mm.
9
0
Share

What problems can a faulty camshaft position sensor cause in a car?

Automobile camshaft position sensor failure can cause the following problems: 1. Impact of camshaft position sensor failure: The camshaft position sensor significantly affects the system's emissions. When the sensor malfunctions, the vehicle may experience difficulty starting; 2. Structure of camshaft position sensor: When the crankshaft position sensor system fails, the camshaft position sensor will utilize cylinder identification signals to provide different controls to various engine components; 3. Fault diagnosis of camshaft position sensor: When the camshaft position does not match the position commanded by the electronic control unit, it will cause the camshaft position sensor to malfunction.
5
4
Share

Where is the OBD port of Dongfeng Citroen C5?

Dongfeng Citroen C5's OBD port is located inside the center console next to the gear shift lever. OBD stands for On-Board Diagnostics in Chinese, which is a diagnostic port that connects the computer to the vehicle's diagnostic system. Through OBD, the working conditions of the engine, sensors, emission control system, fuel system, EGR, and other systems can be monitored in real-time. The Citroen C5 is a mid-size car under Dongfeng Citroen, with a body length, width, and height of 4825mm, 1860mm, and 1480mm respectively, a wheelbase of 2815mm, a top speed of 215km/h, and a body structure of a 4-door, 5-seater sedan.
20
4
Share

What to Do When You Run Out of Gas Midway?

Methods to handle running out of gas midway: 1. Borrow fuel from another car: Prepare a fuel can and a rubber tube, insert the tube into the fuel tank, lower the outlet end of the tube, and the fuel will flow out automatically; 2. Call a tow truck: Tow the car to a gas station, or consider using a friend's car to tow it, but be cautious with soft towing (using a rope to pull); 3. Call for fuel delivery service: Some 4S shops and road assistance companies offer fuel delivery services. When the fuel indicator light on the car dashboard lights up, it means the fuel is about to run out. Generally, the car can still travel about 50 kilometers after the light comes on before the fuel is completely exhausted. The fuel indicator light is controlled by a float sensor in the fuel tank. The sensor monitors the fuel level and sends this signal to the ECU, which then analyzes it comprehensively and displays the result on the dashboard.
3
0
Share

Can a C2 license holder drive a semi-automatic transmission vehicle?

According to regulations, a C2 driver's license allows the holder to operate small and micro automatic transmission passenger vehicles, as well as light and micro automatic transmission cargo vehicles. Since semi-automatic transmission is actually a type of automatic transmission, a C2 license does permit driving semi-automatic vehicles. Here's more relevant information: C2 License: The main demographic choosing to learn C2 consists primarily of middle-aged and elderly individuals, who generally find C2 easier to learn with less risk of stalling. Compared to C1, C2 training is slightly more expensive. C2 learners typically have longer training cycles, and these two factors combined naturally make the training costs higher than for a C1 license. With automatic transmission vehicles, they can basically start moving once ignited, with minimal concern about stalling, and the operational steps are fewer, which is why most applicants are middle-aged/elderly people and women. Although C2 is simpler to learn, the examination requirements are identical to C1, ensuring all learners can drive safely on roads. Due to fewer people learning C2, there's usually a long waiting period before classes begin. A driving school staff member suggests that citizens considering C2 might want to switch to C1 instead – not only is the training cheaper, but they can immediately enroll and start learning subject one.
18
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.