How to reset the tire pressure light on the 2020 New Lingpai?
3 Answers
The method to reset the tire pressure monitoring light on the 2020 New Lingpai is: Turn off the engine, wait for one to two minutes, then start the vehicle. After the vehicle runs stably, check the tire pressure value displayed on the dashboard; Depending on whether the tire pressure is insufficient or too high, inflate or deflate the tires accordingly until the tire pressure monitoring light turns off. According to the international GBT2978-2008 standard, the recommended tire pressures are as follows: Standard tires: 2.4-2.5bar; Reinforced tires: 2.8-2.9bar; Maximum pressure: should not exceed 3.5bar.
Don't panic when the tire pressure light comes on. I experienced this with my 2020 Lingpai before. First, pull over and check all tire pressures against the standard values listed on the sticker inside the driver's door frame - typically around 220kPa for front tires and 230kPa for rear tires. Use a pump to inflate if low, or release some air if overinflated. In most cases, the light will turn off after correction, but sometimes a reset is needed: Sit in the car without starting the engine, turn the key to ON position, locate the TPMS reset button (usually near the steering wheel or instrument cluster), and hold for about 10 seconds until the light blinks and goes off. If there's no button, use steering wheel controls to access the menu and select tire pressure reset. After resetting, test drive briefly to confirm the light stays off. Persistent illumination may indicate sensor failure or system malfunction requiring professional repair. Remember, improper tire pressure affects braking and fuel efficiency - monthly checks prevent recurring warnings and ensure safety.
Driving a 2020 Lingpai when the tire pressure light comes on can be frustrating, but don’t panic, especially if you’re a beginner. Here’s a simplified guide: Find a safe place to park, use a tire pressure gauge to check all four tires, and refer to the door label for the recommended pressure. Inflate any low tires to the specified value. Then, turn on the ignition without starting the engine. Look for a small reset button near the steering wheel—hold it down for about 5-10 seconds while watching the dashboard for the light to flash and turn off. If there’s no button, use the steering wheel controls to navigate the menu, find the tire pressure option, and select reset. After completing these steps, take a short drive to test if the light disappears. If it doesn’t, don’t force it—head to the dealership to check the sensors immediately, as safety comes first. Make it a habit to check tire pressure when the car is cold in the morning for the most accurate reading. This reduces the chance of issues, improves fuel efficiency, and ensures a smoother ride.
