How to reset the tire pressure light on Geely GS?
3 Answers
Press the MENU button on the turn signal lever, select the tire pressure display option in the mileage and fuel information menu, and then press the SET/CLR button. The vehicle's instrument display will show a tire pressure relearning interface. After selecting "Yes," the tire pressure light will disappear. Here are the detailed steps: 1. Press the "MENU" button on the turn signal lever, select the "tire pressure display" option in the "mileage and fuel information menu," then press the Set/Clr button. The driver information center will display "Tire Pressure Relearn," select "Yes," and press the Set/Clr button. The horn will sound twice, and the driver information center will display "Tire Pressure Learning Enabled." At this point, the left front turn signal will stay on. Increase (or decrease) the left front tire pressure by 8.3 Kpa, and once the horn sounds, stop the pressurization (or depressurization) operation. 2. Next, the "right front turn signal will stay on," followed by the right rear and left rear turn signals in sequence. Repeat the pressurization or depressurization operation for the remaining three tires. After all four tires have been operated, the turn signals will stay on for 3 seconds, and the horn will sound twice, indicating the completion of tire pressure learning. Adjust the tire pressure to the desired value. The tire pressure displayed on the information center is the actual tire pressure. If unsure, you can measure it with a tire pressure gauge. If the error is not significant, the process is complete.
I've been using my Geely GS for almost three years, and the tire pressure light has come on several times. Each time, I managed to reset it myself. The method is quite simple: First, find a place to park and use a tire pressure gauge to check the pressure of all four tires, ensuring they're adjusted to the manufacturer's recommended value in cold conditions, usually around 220-240 kPa (refer to the label on the door frame). Then, start the engine without shifting gears, and locate a small button marked with a tire pressure symbol either on the lower left side of the steering wheel or in the dashboard settings. Press and hold it for about 5-10 seconds, and the light will blink and then turn off automatically. If you've just changed tires or refilled them, you might need to drive a few hundred meters to let the system recalibrate. It's a good habit to check the tire pressure monthly to avoid panic when the light comes on and to prevent uneven tire wear and increased fuel consumption, saving both money and hassle. Once, I was too lazy to check, and the car vibrated badly on the highway—a lesson learned the hard way.
Having dealt with cars for many years, a lit tire pressure monitoring light could indicate low pressure or a sensor malfunction. First, use a tire pressure gauge to measure each wheel, ensuring uniform pressure when the tires are cold, and don’t forget the spare tire (if equipped). After adjusting, start the Geely GS’s engine, navigate to the vehicle settings menu in the central control system, and select the tire pressure reset option, or simply press and hold the reset button on the steering wheel for a few seconds until the light turns off. If the light persists, take a short test drive. A drained sensor battery or wiring issues may cause the light to stay on—in this case, use a diagnostic scanner or visit a service station. Avoid sudden braking and rough roads while driving to minimize sensor damage. During regular maintenance, have the TPMS system checked—spending a little ensures safety, as unstable tire pressure can be particularly hazardous in rainy conditions.
