How to reset the tire pressure light on a Beijing BJ20?
4 Answers
Press the MENU button on the turn signal lever, navigate to the tire pressure display option in the mileage and fuel information menu, and then press the Set/Clr button. At this point, the left front turn signal will stay on. Increase the left front tire pressure to 8.3 Kpa, and once the horn sounds, you can stop the pressurization. After completing the operation for all four tires, the turn signal will stay on for 3 seconds, and the horn will sound twice, indicating the completion of tire pressure learning. Adjust the tire pressure to the desired value.
As a former owner of the Beijing BJ20, don't panic when the tire pressure light comes on. First, check if the tire pressure is normal. The recommended pressure values are usually marked on the door frame, typically around 2.3 bar for the front tires and 2.2 bar for the rear tires. After ensuring all tire pressures are correct, sit in the car and turn the key to the ON position without starting the engine. Look for a small button labeled "Tire Pressure Reset" or "TPMS" on the center console—it's usually near the steering wheel and easy to find. Press and hold it for 5 to 10 seconds until you see the dashboard light flash off or hear a beep, indicating a successful reset. Take a short drive to test if the light stays off. If it remains on, there might be a sensor issue requiring a visit to the repair shop. Safety first—address tire pressure issues promptly. I recommend checking your tires every time you refuel to avoid false alarms affecting your driving mood.
I usually drive a Beijing BJ20 to pick up and drop off my kids, and I get really concerned about safety when the tire pressure warning light comes on. The reset procedure is simple: first, get out of the car to ensure the tires aren't leaking and the pressure is correct—the door label has the reference values. Then, turn the key to the ON position without starting the engine, locate the tire pressure button on the center console, and hold it down for a few seconds until the light goes off. If the light remains on after resetting, there might be a genuine tire pressure issue or a sensor malfunction—get it checked promptly to avoid delays. Remember, the tire pressure must meet the standard before resetting; don’t skip steps to save effort. Regular tire maintenance can reduce false alarms—like me, I check the pressure weekly while washing the car, a good habit to prevent problems in advance.
Bro, resetting the tire pressure light on a Beijing BJ20 off-roader is a piece of cake. First, measure and inflate the tires to the standard pressure—check the specific value on the door B-pillar label. Get in, turn the ignition to ON (don't start the engine). Locate the tire pressure reset button on the center console, hold it for about 10 seconds until the light goes off. Drive a short distance to confirm the light stays off. If it doesn’t, inspect the tires or sensors immediately. Don’t forget to test with normal driving after resetting.
