How to reset the tire pressure light on a 2012 base model Tiguan?

1 Answers
Rhonda
07/24/25 4:01am
Method to reset the tire pressure light on a 2012 Tiguan: 1. First, ensure that the air pressure in all four tires is consistent. Then, locate the tire pressure reset button near the gear lever or the glove compartment. 2. Follow the prompts until you see a message indicating that the tire pressure detection is complete and reset. 3. Turn on the ignition and hold the button until you hear a beep, indicating that the reset is complete. Introduction to the Tiguan: 1. The Tiguan is a vehicle produced by Shanghai Volkswagen, available in four versions: Urban, Trendline, Comfortline, and Highline. 2. The Tiguan is powered by Volkswagen's 1.8TSI and 2.0TSI engines, paired with a 6-speed manual transmission or an Aisin 6-speed automatic transmission, delivering better performance while maintaining lower emissions.
Was this review help?
15
2
Share
More Forum Discussions

Why does the Magotan engine shake when started?

Here are the specific reasons for the Magotan engine shaking when started: 1. Shock absorber system failure: The shock absorber system is mainly responsible for filtering the vibration of the engine during operation. If there is a problem with the shock absorber, these vibrations will be directly transmitted to the steering wheel and the interior of the car, affecting driving. When the engine is idling, turning on the electrical system in the car can also easily cause shaking. The engine increases the load due to the activation of electrical appliances, causing the idle speed to drop. To compensate for the shaking caused by the idle speed drop, the engine will automatically increase the speed. 2. Unstable oil pressure: Check whether the fuel supply pressure and intake pressure sensor are normal. If the fuel pump supply pressure is abnormal or the intake pressure sensor value is incorrect or not working properly, it will cause the car body to shake. 3. Cold start: The main reason for the car body shaking during a cold start is insufficient fuel combustion, which leads to insufficient power of the car. The ignition energy is low. When starting, when the temperature of the fuel and lubricating oil is low, it is necessary to rely on more fuel to meet the power demand. Over time, the gap between the poles of the spark plug will gradually increase, leading to a decrease in ignition energy and poor fuel atomization, which will cause the car body to shake. In addition, aging of the ignition coil, aging of the high-voltage wire of the spark plug, or leakage can also lead to a decrease in ignition energy.
4
4
Share

How to Decelerate a Manual Transmission Car?

When decelerating a manual transmission car, you should press the brake while downshifting. First, release the accelerator to cut off the forward power, allowing the vehicle to decelerate through air resistance and ground friction. You can combine this with braking for quicker deceleration. When the vehicle is about to shake in the current gear, quickly downshift and then slowly release the clutch to shift into the appropriate gear. A manual transmission, or manual gearbox, requires the driver to manually move the gear lever to change the gear engagement inside the transmission, altering the gear ratio to achieve speed adjustment. The working principle of a manual transmission: The shift fork changes the gear ratio of the meshing gears, thereby altering the driving torque to suit different driving conditions.
6
5
Share

Does mixing 92 and 95 octane gasoline affect the car?

If you have been using 92 octane gasoline and want to temporarily switch to 95 octane, there will be no adverse effects. However, it is not recommended to mix these two types of gasoline for extended periods, as long-term mixing of different octane ratings can impact the lifespan of the car's ignition system, fuel injectors, and spark plugs. While it is possible to mix lower octane gasoline with higher octane gasoline, the reverse (mixing higher octane with lower octane) is not advisable. Except in emergencies, avoid mixing gasoline as it may lead to insufficient vehicle power. If mixing is necessary, you can add fuel additives for cleaning afterward. Gasoline is a volatile, flammable hydrocarbon mixture liquid derived from petroleum through fractional distillation, cracking, or pyrolysis, used as fuel and appearing as a transparent liquid.
11
4
Share

Are Hybrid Vehicles Eligible for Green License Plates?

Conventional hybrid vehicles are not eligible for green license plates, while plug-in hybrids are. Below are the specific advantages of green-plate vehicles: Energy Efficiency of Green-Plate Vehicles: New energy vehicles are energy-efficient because electric motors are far more efficient than internal combustion engines. Electricity costs significantly less than gasoline, directly resulting in lower daily operating expenses. Additionally, given the non-renewable nature of petroleum fuels, the significance of using new energy vehicles becomes even greater. Quick Acceleration of Green-Plate Vehicles: These vehicles start instantly with just a turn of the key. Under acceleration conditions within 100 kilometers, they can cover more distance than conventional fuel-powered vehicles. Air conditioning can be turned on immediately upon entering the vehicle, and with no transmission, the driving experience is perfectly smooth.
13
4
Share

Is Wheel Traffic Violation Query Accurate?

Based on the usage experience of most users, Wheel Traffic Violation Query is quite accurate. However, for more precise violation information, you can consult local relevant departments or use self-service violation query machines. For safety reasons, vehicle owners can check their vehicle's violation records across multiple platforms. This helps avoid additional troubles if legal responsibilities aren't cleared after the violation elimination period. If you receive a violation, you can pay the fine online without queuing at traffic police stations, saving time and effort. Currently, Wheel supports handling electronic police and sticker parking violations, with the fastest processing time of 5 hours for on-site tickets and adjudication tickets. Direct connection with banks makes online payment very convenient.
3
4
Share

What is the best water to use for car window tinting?

Car window tinting uses clean water. Here are the benefits of applying film to car windows: Enhanced Safety: Anti-shatter properties to prevent injuries from flying glass; UV protection to shield against harm to the human body, dashboard, and leather seats; anti-glare function to reduce the impact of sunlight, oncoming headlights, or snow glare; increased privacy, making it difficult to see inside the car from the outside; scratch resistance to maintain clear visibility. High-quality car films have an outer scratch-resistant layer that ensures the surface remains unscratched during normal use, maintaining clear visibility and thereby improving driving safety. Improved Comfort: Heat insulation to reduce the sensation of heat inside the car; shorter cooling time for the air conditioning after parking, reducing energy consumption. Enhanced Aesthetics: Decorative function, with color coordination that can enhance visual appeal.
5
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.