How to Reset the Subaru Outback Maintenance Light?

[LaBryce]

During maintenance, have the personnel at the 4S dealership use a computer to set it. Press the trip meter reset switch, and the trip meter will light up, allowing you to toggle between trip meter A and trip meter B. Press the trip meter reset switch, select trip meter A or trip meter B, and hold the button for more than 2 seconds to reset the trip meter. Turn the ignition switch to the ON position, and the maintenance light will disappear.

[LilyFitz]

Speaking of resetting the maintenance light on my Subaru Outback, I've gained quite some experience. Generally, you need to sit in the driver's seat, turn the key to the ON position without starting the engine, and let the dashboard light up. Then, locate the ODO TRIP button near the steering wheel, press and hold it for about 6 to 10 seconds, patiently waiting for the maintenance indicator light to start flashing or turn off. Release the button, and the light will be reset. I drive a 2016 model, and it's worked successfully every time I've tried. The whole process is simple and takes no more than half a minute. However, note that the button location may vary for different model years. If it doesn't work at first, try a few more times or check the owner's manual. Regularly resetting it reminds you to perform maintenance, which is good for the car's longevity. Don't slack off—actual maintenance is more important, or the light will come back on soon. In short, doing it yourself saves time and money.

[Elias]

I recently tried resetting the Outback's maintenance light and found it quite easy. First, get in the car, turn the key to the ON position without starting the engine, just powering up the dashboard. Then press and hold the ODO button on the left side of the instrument panel until it flashes a few times and turns off automatically. Initially, I didn't hold it long enough—just 5 seconds with no response—but waiting 10 seconds did the trick. A reminder: make sure the car is safely parked during this process. After resetting, it reminded me about the upcoming maintenance, which is much more convenient than going to the shop. My car is a 2019 model, and I've heard older models might have slightly different steps, but they're generally similar. If the light stays on, it could mean the maintenance wasn't actually done or there's another minor issue. My personal advice: regularly check the manual yourself rather than relying solely on the light. Giving it a try won't hurt.

[LeLogan]

The Subaru Outback maintenance light reset procedure is straightforward. Method: Turn the ignition to ON, locate the ODO TRIP button, press and hold for approximately 5-8 seconds until the maintenance indicator light flashes or turns off. Release the button to extinguish the light. Key point: Do not start the engine, only turn on the ignition. The entire process takes about 20 seconds. If unsuccessful, repeat the procedure. Minor variations exist between model years, but post-2010 vehicles generally follow this method. Ensure maintenance has been completed before resetting. Safety first—perform this operation on level ground. The light turning off indicates the counter has been reset; regular maintenance extends vehicle lifespan. Simple and effective, no tools required.