How to Reset the Maintenance Wrench Light on Roewe 350?

[ElizabethLee]

Turn off the car, press and hold the right button on the dashboard (the reset button), then turn on the ignition switch while keeping the reset button pressed for several seconds. Enter the reset mode, at which point you can release the reset button. Within 20 seconds of releasing the reset button, press the left button on the dashboard to confirm the reset. At this point, the maintenance light will return to the normal display mode, effectively eliminating the flashing maintenance light.

[NovaLynn]

When I first drove the Roewe 350, I encountered the maintenance wrench issue. It's easy to fix in just a few steps: First, insert the key and turn it to the power-on position without starting the engine, allowing the dashboard to light up. Then locate the trip display button on the dashboard, usually near the right side of the steering wheel, and hold it down firmly. Wait until the wrench light starts flashing or goes out before releasing the button. The whole process takes just a few seconds and is very straightforward. After resetting, don't forget that this is a reminder to change the oil or perform routine maintenance. I recommend scheduling it as soon as possible to avoid dust buildup or more minor issues, such as poor engine performance. Doing it yourself saves both time and money.

[DeSkylar]

As a car owner, I found the method to reset the maintenance indicator light on the Roewe 350: First, start the vehicle and immediately turn off the engine. Then, press and hold the Trip button on the dashboard without releasing it, while turning the key to the ACC position. At this point, the dashboard will light up. Continue holding the button for about 5 to 10 seconds until the wrench icon disappears, then release. This process involves the car's computer system and is very easy to operate. However, I must remind you that resetting only clears the prompt. If the mileage has been reached, you still need to go to the 4S store to change the oil and check the filter. Otherwise, long-term neglect may affect the performance of the transmission or air conditioning, which would be more costly in the long run.

[BrodyLynn]

To reset the maintenance wrench light on the Roewe 350 is straightforward: Insert the key and turn it to the ON position without starting the engine. Press and hold the trip reset button on the instrument panel, wait a few seconds until the wrench light goes off. Remember to perform the vehicle maintenance promptly after completion.

[DeBarrett]

Let me teach you how to reset the maintenance reminder on the Roewe 350: Get in the car, turn the key to the ignition position (dashboard lights on but don't start the engine). Hold down the trip button for several seconds until the wrench icon flashes - that's it done. Don't assume everything's fine though - you must actually change the oil when due, otherwise the engine will consume more fuel and run noisily. DIY method is quick and safe.

[LaOwen]

The maintenance wrench light is a service reminder for the Roewe 350. To reset it: turn the key to the ACC position, then press and hold the Trip button on the dashboard until the icon disappears. This method is simple and convenient, helping to avoid component wear caused by overdue maintenance. I often reset it myself to save the hassle of visiting a repair shop, but don't neglect the maintenance schedule—it's best to check the fluids every 5,000 kilometers.