How to reset the maintenance reminder on Zhonghua V3?
2 Answers
The method to reset the maintenance reminder on Zhonghua V3 is: 1. Turn off the ignition button of the car; 2. Press and hold the maintenance reset button on the car's dashboard for a long time; 3. While holding the maintenance reset button, press the car's start button to start the vehicle; 4. When the car display shows 0000.0, release the maintenance reset button to clear the maintenance light. The Zhonghua V3 is a compact SUV with body dimensions of 4240mm in length, 1803mm in width, and 1600mm in height, a wheelbase of 2570mm, a fuel tank capacity of 52 liters, and a minimum ground clearance of 170mm.
I've been driving my Zhonghua V3 for over two years, and resetting the maintenance reminder is actually quite simple. First, make sure the vehicle is turned off. Locate the small round button at the lower right of the instrument panel, press and hold it while turning the key to the ON position (don't start the engine). At this point, you'll notice the wrench icon next to the odometer starts blinking. Then release the button and press it again for a few seconds until the icon disappears. However, note that the button position may vary for different model years - some are located on the left side of the steering wheel. If it doesn't work on the first try, it might be because you didn't press long enough or the vehicle hasn't fully entered reset mode. I recommend trying a couple more times. If it still doesn't work, check the maintenance manual in your glove box - it definitely contains illustrated instructions. I always do this myself after maintenance to avoid the hassle of queuing at the service center.
