How to reset the maintenance reminder on Volkswagen Lavida Plus?

What is the motor power of the BAIC New Energy EC5?

BAIC New Energy EC5's motor power is 70 kilowatts. Here is more information about this vehicle: 1. The BAIC New Energy EC5 is a new energy vehicle under BAIC. In terms of power, it is equipped with a permanent magnet synchronous motor with a maximum torque of 200 Nm. The transmission system paired with the motor is a single-speed electric vehicle gearbox. 2. The BAIC New Energy EC5 is equipped with a power recovery system. During driving, excess power generated is recovered, which can enhance the vehicle's range. As the circuit layout of this system is more simplified, it reduces the incidence of vehicle failures and improves the reliability and stability of the car.

10

3

Share

Is the tire noise loud for the Bora?

The tire noise of the Bora is within the normal range. Generally, loud tire noise may be caused by resonance, which creates a specific speed-related humming noise. All cars have noise; the key is whether it is acceptable. Reducing tire noise: Adding soundproofing cotton to the inner fender liner can reduce tire noise. If higher noise reduction is required, vibration damping and sound insulation treatment should also be applied to the wheel arch steel plate. A layer of sound-absorbing cotton can be attached to the inner liner. Reducing lateral tread movement can also effectively minimize tire noise. Bora: The latest model of the all-new Bora incorporates more of the newest design elements in its front fascia. The sharp headlight cluster integrates with the horizontal chrome grille while adopting a full-width front bumper design.

17

4

Share

How to set up the automatic door lock for the Levin?

The Levin does not have an automatic door lock function, so it cannot be set up. The purpose of the automatic door lock function is to prevent theft, protect against door-pulling robberies during traffic jams or at red lights, and safeguard child passengers inside the car by preventing them from opening the door handles while the vehicle is in motion. Taking the 2021 Levin as an example, it is a compact car with the following dimensions: length 4640mm, width 1780mm, height 1455mm, wheelbase 2700mm, front track 1527mm, rear track 1526mm, fuel tank capacity 50 liters, and trunk capacity 471 liters.

6

4

Share

What are the reasons for no braking when pressing the air brake hard?

The reasons for no braking when pressing the air brake hard are as follows: 1. Lack of brake fluid: Leakage in the brake wheel cylinder, pipelines, and joints, potential damage to the master cylinder or wheel cylinder. 2. Presence of air in the brake system. 3. Excessive gap between the friction pads and the brake drum. 4. Overheating of the brake disc. Precautions for air pressure are as follows: 1. After starting the vehicle, the onboard air pump must be used. 2. Do not blindly choose to use an inflator pump; replace it immediately if there are issues, and check the tire pressure immediately if abnormal. 3. Avoid prolonged use of the inflator pump to prevent overheating and damage.

2

0

Share

Is the Air Conditioning Set to Cooling Mode in Summer?

In summer, the air conditioning is set to cooling mode. Its working principle involves drawing low-temperature, low-pressure refrigerant into the cylinder. Through the operation of the compressor, the pressure increases until it exceeds the pressure in the condenser, allowing it to transform into cold air. The entire refrigeration system undergoes four processes: compression, condensation, expansion, and evaporation, forming a cycle that enables the air conditioner to blow out cold air. The air conditioning system consists of a compressor, an electronically controlled clutch, a condenser, an evaporator, an expansion valve, a receiver-drier, piping, a condenser fan, a vacuum solenoid valve, an idle speed controller, and a control system. The functions of air conditioning include: 1. Adjusting the interior temperature; 2. Humidity regulation; 3. Airflow adjustment; 4. Air purification.

15

3

Share

What are the reasons for seat belts not retracting?

Seat belts not retracting can be caused by: 1. The upper slider of the seat belt being too close to the B-pillar, causing misalignment between the belt in the slider and the belt in the retractor box, leading to jamming during automatic retraction; 2. The lower roller not immediately returning to its position; 3. Debris in the friction area between the B-pillar seat belt buckle and the belt; 4. Damage to the seat belt buckle. The function of seat belts is to instantly tighten during vehicle collisions or emergency braking, securing the occupant firmly in the seat to prevent secondary collisions by eliminating slack in the belt.

3

2

Share

How to reset the maintenance reminder on Volkswagen Lavida Plus?

What is the motor power of the BAIC New Energy EC5?

Is the tire noise loud for the Bora?

How to set up the automatic door lock for the Levin?

What are the reasons for no braking when pressing the air brake hard?

Is the Air Conditioning Set to Cooling Mode in Summer?

What are the reasons for seat belts not retracting?

What is the braking distance of the Venucia T60 in meters?

Is the car film applied on the inside or outside of the car?

Is the Leiling spare tire full-size?

What transmission does the Haoying use?