How to Reset the Maintenance Reminder on the New Magotan?

1 Answers
CalvinAnn
07/30/25 7:39am
To reset the maintenance reminder on the new Magotan, you can press and hold the right button on the instrument panel, insert the key, release the right button, and then enter the maintenance interface to restore default values when the 'Clear Maintenance Cycle' menu appears. Below is a detailed introduction to the method for resetting the maintenance reminder on the new Magotan: 1. Inspect the protective coating: Check whether the protective coating on the underside of the body is damaged. 2. Check the multi-ribbed belt: Replace it if necessary. 3. Inspect the left and right control arm hinges and rear axle hinge: Check whether the left and right control arm hinges and rear axle hinge are damaged or malfunctioning. Additionally, the brake fluid must be replaced every two years or 50,000 kilometers, and the brake warning system and brake booster should be inspected. For manual transmission vehicles, the transmission gear oil should be replaced every 12 months or 5,000 kilometers. For vehicles equipped with an automatic transmission, the transmission gear oil should be checked regularly and replaced every 30,000 kilometers.
Was this review help?
13
3
Share
More Forum Discussions

How to adjust the time on a 2017 Octavia?

2017 Octavia time adjustment method: 1. Locate the black cylindrical knob on the instrument panel, turn it to the left to make the hour hand flash, allowing you to adjust the hour - press once to increase by one hour; 2. Turn it to the right to make the minute hand flash, allowing you to adjust the minutes - press once to increase by one minute (only increase, no decrease). The 2017 Octavia has body dimensions of: length 4659mm, width 1814mm, height 1460mm, wheelbase 2686mm, and a curb weight of 1210kg. The 2017 Octavia is equipped with a 1.6L turbocharged engine, delivering a maximum horsepower of 110PS, maximum torque of 155Nm, maximum power of 81kW, paired with a 5-speed manual transmission.
6
5
Share

What is the solution for K5 sunroof rattling?

K5 sunroof rattling solutions are: 1. Fully open the sunroof and spray maintenance agent on the sealing rubber strip; 2. Tighten the sunroof screws; 3. Clean dust particles from the sunroof slide rails. The functions of a sunroof are: 1. Release toxic gases inside the vehicle; 2. Prevent vehicle exhaust fumes; 3. Lower the interior temperature; 4. Effectively reduce wind noise; 5. Eliminate fogging. The K5 body dimensions are: length 4980mm, width 1860mm, height 1445mm, with a wheelbase of 2900mm. The 2020 K5 K5 KaiKu Fashion Edition is equipped with a 1.5L turbocharged engine, producing a maximum horsepower of 170PS, maximum power of 125kW, maximum torque of 253Nm, paired with a 7-speed dual-clutch transmission.
11
3
Share

Is it a problem if the handbrake is adjusted too tight?

Adjusting the handbrake too tight is very bad for the vehicle. It can easily wear out the handbrake cable and cause the braking system to overheat, which is harmful to the entire wheel. This can lead to excessive fuel consumption, wheel lock-up during braking, and rapid tire wear. Method to determine handbrake tightness: If the car can be pushed without pulling the handbrake, then the handbrake is fine. Standard method to test handbrake tightness: Park the car on a flat road without pulling the handbrake and try to push it. If it moves and slows down gradually when released, the handbrake is properly adjusted. Experienced individuals often adjust the handbrake by slowly counting the clicks when pulling it—usually, the handbrake is properly adjusted by the third click.
17
5
Share

What are the reasons for the Magotan not responding when pressing the ignition start?

The reasons for the Magotan not responding when pressing the ignition start are: 1. The vehicle's battery power is too low; 2. The fuel pump is damaged, preventing fuel in the fuel tank from being supplied for combustion; 3. The engine crankshaft position sensor or camshaft position sensor is damaged; 4. The engine lacks cylinder pressure. The Magotan is a mid-size car under FAW-Volkswagen, with body dimensions of 4865mm in length, 1832mm in width, and 1471mm in height, a wheelbase of 2871mm, a minimum ground clearance of 135mm, and a body weight of 1445kg. The Magotan is equipped with a 1.4T inline 4-cylinder turbocharged engine, delivering a maximum horsepower of 150ps, paired with a 7-speed dual-clutch transmission.
20
2
Share

What are the differences in driving techniques between flat-nose and long-nose trucks?

Driving techniques are the same, but visibility and sense of direction differ. Advantages of long-nose trucks: Long-nose trucks are relatively cheaper, easier to maintain and repair, have more spacious cabs (providing greater comfort), and offer higher safety for drivers. With the engine positioned at the front, noise, vibration, and heat are not directly transmitted to the cab. Advantages of flat-nose trucks: Higher efficiency, lower fuel consumption, reduced emissions, and lighter weight. For vehicles of the same total length, the cargo compartment of a long-nose truck is smaller than that of a flat-nose truck. The visibility from the cab of a long-nose truck is inferior to that of a flat-nose truck. Flat-nose trucks have higher steering sensitivity and relatively lower damage rates.
7
3
Share

What is the difference between Auto Hold and Hill Start Assist?

Auto Hold and Hill Start Assist are two different functions. Although both are derived from the ESP system in terms of implementation principles, their usage scenarios differ. Here are the specific details: 1. The Hill Start Assist System is a function developed based on the ESP system. It allows the vehicle to maintain braking for a few seconds when starting on a slope without using the handbrake, even after the driver's right foot leaves the brake pedal. This enables the driver to easily transition their foot from the brake pedal to the accelerator pedal, preventing rollback accidents and avoiding any sense of panic. 2. The Auto Hold function uses a slope sensor to provide precise parking force through the controller. During startup, the parking control unit calculates information from sensors such as the clutch distance sensor, clutch engagement speed sensor, and accelerator pedal sensor. When the driving force exceeds the running resistance, the parking brake is automatically released, allowing the car to start smoothly.
1
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.