How to reset the maintenance reminder for the Vision X6?
3 Answers
There are two methods to reset the maintenance reminder for the Vision X6: one is to press and hold the mute button while starting the car to enter the maintenance interface and clear it, and the other is to visit a 4S shop for maintenance. The specific steps to reset the maintenance light for the Vision X6 are as follows: 1. Press and hold the maintenance reset shortcut: Press and hold the maintenance reset shortcut on the dashboard of the Geely Vision X6 without releasing it; 2. Step on the brake pedal: Step on the driver's brake pedal of the Geely Vision X6; 3. Turn the car key: Turn the car key of the Geely Vision X6 to the 'on' position; 4. Release the shortcut after the dashboard lights up: Release the maintenance reset shortcut after the dashboard of the Geely Vision X6 lights up; 5. Press the OK button to confirm: Press the OK button on the multifunction steering wheel of the Geely Vision X6 to confirm, and the maintenance light of the Geely Vision X6 will be reset.
Maintenance reset is actually not difficult. I've tinkered with my Vision X6 several times myself, and it feels much simpler than other cars. First, find a safe place to park, turn off the engine, engage the parking brake, and shift to P. Then, turn the ignition switch to the ON position without starting the engine—just make sure the dashboard lights up. Next, press and hold the TRIP button (that small button on the left side of the steering wheel) for about five seconds until the maintenance reminder light flashes and goes off. If it doesn't respond, try again. Once reset successfully, the system will restart the maintenance cycle count, which is very helpful for reminding you of the next service time. Don't forget to regularly check the engine oil and filters, and pay attention to road conditions while driving—never attempt this while on the road, as it's dangerous. Honestly, after doing it a few times, you'll get the hang of it—saving both money and hassle.
I've been driving the Geely Vision X6 for a while, and that maintenance light keeps bothering me after service. The reset steps are: first park the car stably and turn off the engine, shift to P gear for safety. Turn the ignition switch to ON position, but don't start the engine. Locate the TRIP button near the steering wheel, press and hold it for about ten seconds until the maintenance light goes off, indicating completion. Normally after this operation, the car will record a new starting point to help track the maintenance schedule. It's recommended to confirm completion of oil change and other tasks before resetting. If the light doesn't go off, check the manual or visit the service center - safe driving is most important.
