How to reset the maintenance reminder for Ford EcoSport?

1 Answers
DeDallas
07/29/25 5:52pm
Ford EcoSport maintenance reminder reset procedure is as follows: 1. First, close all doors and windows; turn the ignition switch to OFF position (for push-start vehicles). 2. Simultaneously press and hold the accelerator and brake pedals for 2-3 seconds until a prompt appears on the instrument cluster information center, then maintain this for 10 seconds (the mileage display will count down from 10, 9, 8... to 0). 3. After holding for 10 seconds, the message "completed" will appear, indicating successful reset. You may then release the pedals, turn off the engine, and restart the vehicle.
Was this review help?
6
0
Share
More Forum Discussions

Can Honda Hybrid Batteries Last 15 Years?

They can last for 15 years. Honda's hybrid vehicles come with a battery warranty of 10 years or 200,000 kilometers. Honda hybrid batteries employ a shallow discharge method, which increases the number of charge cycles and thereby extends the battery's lifespan. Here's the relevant information: Honda's hybrid technology is quite advanced and follows a unique approach. Honda's hybrid system operates as an independent system. Users can drive in pure electric mode or switch to gasoline engine mode, unlike Toyota's hybrid models which require coordination between both power sources to operate.
6
5
Share

What is the speed limit at intersections?

Traffic intersections have a speed limit of 60 mph. Here are the relevant details: 1. Precautions: The speed at crossroads should generally be 40 mph. Article 29 of Traffic Regulations states: When a motor vehicle passes through an intersection, it should reduce speed at a distance of 30 to 50 meters, using turn signals to indicate the direction of travel; at night, the headlights must be switched to low beams or dipped beams. 2. Additional Information: There are no specific regulations regarding the exact speed at crossroads. Drivers should determine their speed based on the current road conditions, paying attention to traffic signs and signal lights. To prevent pedestrians or non-motorized vehicles from suddenly appearing, the speed is generally controlled within 40 mph.
5
1
Share

Why Can't the Car Move in Reverse?

It is mainly a transmission issue, requiring checks on oil pressure, solenoid valves, and the valve body. Below are the detailed explanations: 1. Gear Control: When reversing, ensure the car is completely stationary before shifting the gear selector to the R position; otherwise, it may damage the shift actuators or the parking lock mechanism in the automatic transmission. 2. Slow Speed: On flat surfaces, after releasing the brake pedal and handbrake, the car can reverse slowly at idle speed without pressing the accelerator pedal. 3. Accelerator Control: If reversing over steps or obstacles, gently press the accelerator pedal and brake promptly after overcoming the obstacle.
15
3
Share

What Causes Tesla Air Conditioning Not to Cool?

Tesla air conditioning may not cool due to the compressor protection device tripping or electrical circuit issues. Here are the specific details: 1. High pressure or overheating: Excessive refrigerant. Reduce the refrigerant amount appropriately. Poor heat dissipation. Check the condenser tube for dust and clean the condenser. Blockage in the pipeline system. Refer to the pressure gauge for judgment, troubleshooting, and system reprocessing. Dust accumulation or scaling on the evaporator or filter. 2. Electrical circuit issues include: Control circuit board failure. Temperature sensor overload, incorrect information. Loose or poor contact in power wiring. Burnt-out starting capacitor or compressor starting coil.
14
1
Share

What Causes the Rattling Noise in the H6 Transmission?

Here are the reasons for the rattling noise in the H6 transmission: 1. Bearing wear: Loose bearings due to wear, deformation of the shaft or housing causing changes in the center distance between meshing gears and misalignment of axes. 2. Spline groove wear: Wear of the sliding keyway on the shaft and the internal spline groove of the sliding gear; loose fastening bolts in the control mechanism and wear or deformation of the shift fork, leading to gear displacement. 3. Improper operation: Incorrect driver operation, such as aggressive starts or poor coordination between hand and foot during gear shifting, can cause significant impact loads in the transmission, resulting in broken or shattered gear teeth and subsequent noise.
17
0
Share

Which Lane is the Slow Lane?

On roads with two or more motor vehicle lanes in the same direction, the left lane is the fast lane, and the right lane is the slow lane. Related information: 1. Introduction: The fast lane is dedicated to passenger cars, while the slow lane can be used by both passenger cars and trucks. 2. Notes: Motor vehicles driving in the fast lane should maintain the speed specified for the fast lane. If they cannot reach the specified speed, they should move to the slow lane. Motorcycles should drive in the far-right lane. If there are traffic signs indicating speed limits, drivers should adhere to the posted speed limits. When a vehicle in the slow lane needs to overtake the vehicle in front, it may temporarily use the fast lane.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.