How to reset the maintenance light on Zotye T200?
3 Answers
The steps to reset the maintenance light on Zotye T200 are as follows: 1. Turn on the ignition switch, press and hold the "Reset Button 5" with one hand, then turn off the ignition switch with the other hand. 2. Keep holding the "Reset Button 5" until the clock and mileage on the dashboard completely disappear (the dashboard should display nothing, black screen), then release the button. 3. Press and hold the "Reset Button 5" again with one hand, then turn on the ignition switch. At this point, the maintenance reminder on the dashboard will flash. Continue holding the "Reset Button 5" without releasing until the maintenance reminder stops flashing, then release the button. 4. Turn on the ignition switch or start the vehicle again to check if the reset was successful.
As a long-time owner of a Zotye T200, I've found the method to reset the maintenance light quite straightforward. Turn off the engine and rotate the key to the OFF position. Locate the small reset button on the instrument cluster and press and hold it. Then turn the key to the ON position (without starting the engine), continuing to hold the button for about 10 seconds until the maintenance light flashes or turns off. Release the button, turn off the ignition, and restart to check if the light remains off. If unsuccessful, the button might not be properly aligned or positioned - it's best to consult the user manual for specific steps with illustrations. After resetting, don't delay - promptly visit a 4S shop or repair facility for maintenance. Remember, the light is just a reminder; your oil or filters may already be overdue, and neglecting this could shorten engine life and increase repair costs.
I've dealt with the maintenance light on my Zotye T200 a few times myself, and the reset steps are quite straightforward. First, turn off the engine and remove the key, then press and hold the reset button on the dashboard (usually a small dot). Next, reinsert the key and turn it one position to the accessory position without starting the engine. Hold the button for about 5 seconds until the light goes off, then release it. Make sure all dashboard lights are on during the process. If the light doesn't go off, try pressing the button a few more times or adjusting its position, and refer to online tutorials for additional guidance. After resetting, don't forget to schedule a maintenance check, as regular inspections can prevent major issues. For simple troubleshooting, you can check the OBD port, but avoid disassembling anything yourself to prevent damage to the vehicle.
