How to reset the maintenance light on the Geely Vision X3?
2 Answers
The method to reset the maintenance light on the Geely Vision X3 is: 1. Turn off the vehicle and locate the maintenance light reset button on the instrument panel, then press and hold the maintenance light reset button on the instrument panel; 2. Start the vehicle while continuing to hold the maintenance light reset button to enter the reset mode for the vehicle maintenance cycle indicator; 3. Release the maintenance reset button on the instrument panel and press button 'A' within 20 seconds. Taking the 2020 Geely Vision X3 as an example, it is a compact SUV with body dimensions of: length 4005mm, width 1760mm, height 1575mm, wheelbase 2480mm, and a curb weight of 1180kg. The 2020 Geely Vision X3 is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 109PS, maximum torque of 142Nm, and maximum power of 80kW.
As a veteran owner of the Geely Vision X3 for over a decade, I'm quite familiar with resetting the maintenance reminder light. Turn off the ignition switch, press and hold that small reset button on the instrument panel - usually located on the left side. Then turn the ignition switch to the ON position without starting the engine, count 5 to 10 seconds until the maintenance light blinks or turns off, release the button and turn off the switch to complete the process. After resetting, the light will stay off, but this reminder is actually crucial as it automatically counts based on vehicle mileage. Resetting means it's time for maintenance to prevent oil degradation and engine wear. I always reset it immediately after each service to avoid misinterpreting the light as a fault later. If the button doesn't respond, check the manual for specific instructions. Remember, regular oil and filter changes extend your car's lifespan - don't cut corners on maintenance to save small money at the cost of your vehicle's health.
