How to reset the maintenance light on the Exeed TXL?
2 Answers
Here are the steps to reset the maintenance light on the Exeed TXL: 1. Turn off the ignition switch. 2. Press and hold both arrow buttons simultaneously, then turn on the ignition switch. 3. Release the two arrow buttons after approximately 3 seconds. 4. The maintenance menu will appear, asking if you want to reset. 5. Press and hold the SET (reset) button for more than 3 seconds. 6. Press the MODE button. 7. Turn off the ignition switch to complete the reset. Below are specific details about the Exeed TXL: 1. The side design is basically the same as the previous model, with a length of 4780mm and a wheelbase of 2800mm. 2. In terms of power, the Exeed TXL is still equipped with a 1.6T engine, paired with a 7DCT transmission, and the engine can output up to 197 horsepower.
Resetting the maintenance light on the Exeed TXL is actually quite simple. I've helped my neighbor do it twice, and it takes about two minutes to complete. The main steps involve using the control buttons behind the steering wheel. First, start the car but don't drive it. Then, press and hold the knob on the right side of the instrument panel for about ten seconds until the maintenance reminder interface appears. Next, use the buttons on the left side of the steering wheel to navigate to the 'Maintenance Reset' option and press the confirm button to execute the reset. Remember not to release the knob during the process—wait until the instrument panel displays a successful reset before letting go. Afterward, turn off the car and restart it to check if the indicator light has turned off. If the steps are followed correctly, it should work on the first try. The menu position may vary slightly depending on the model year, so if you can't find it, just refer to the owner's manual.
