How to Reset the Maintenance Light on the Envision?
4 Answers
To reset the maintenance light, turn the ignition to ON/RUN with the engine off. Use the up or down buttons on the right side of the steering wheel to navigate to the oil life percentage display. Then, press and hold the round button with a √ symbol in the middle of the right side of the steering wheel until the oil life display changes to 100%. Below is some information about the car maintenance light: 1. Car maintenance refers to the periodic inspection, cleaning, replenishment, lubrication, adjustment, or replacement of certain parts as a preventive measure, also known as car servicing. The purpose of car maintenance is to keep the vehicle clean, ensure normal technical conditions, eliminate potential hazards, prevent faults, slow down deterioration, and extend the service life. 2. When the vehicle reaches a certain mileage, a specific symbol indicator light will appear on the dashboard to remind the owner to perform maintenance. This indicator is called the car maintenance light. After the vehicle is serviced, the maintenance light will not turn off by itself and requires a specific method to reset it, which is known as maintenance light reset.
As an experienced DIY driver, I'd like to share the method for resetting the maintenance light on the Envision. The key is to operate through the vehicle's menu: First, park the vehicle completely, turn off the engine, and wait a few minutes for the system to reset. Then, insert the key and turn it to the ON position without starting the engine. At this point, hold down the arrow button or control lever on the right side of the steering wheel while observing the central information display on the dashboard. Once the menu pops up, select 'Vehicle Information' or a similar option, then navigate to the 'Maintenance Reminder' section. Inside, you'll find a 'Reset Maintenance Indicator' button. Press and hold the confirmation button for a few seconds until the light goes off. If it doesn't work, it might be due to low battery power or a system malfunction, so it's best to check the owner's manual or visit a 4S shop for inspection. Remember, resetting the light promptly is necessary to avoid constant reminders that can distract you while driving and waste money. However, don't skip maintenance just to save money, as it could damage the engine and cost you more in the long run.
I think this issue is very important, as resetting the maintenance light is related to safe driving habits. The operation for resetting the indicator light on the Envision is quite simple: first, ensure the car is in the P (Park) position and the key is turned to the ACC position without starting the engine. Then, look at the steering wheel, find the left control lever or button panel, press and hold the 'Info' button for about 5 seconds, and the dashboard will display a menu. Navigate to 'Settings' or 'Driver Information Center,' find the maintenance reminder option, and click to reset. If it doesn't work after trying, don't force it by pressing hard, as this may cause electronic system malfunctions, which would be counterproductive. I recommend letting a technician handle it after regular maintenance—they can do it instantly with professional tools, avoiding any accidental damage from incorrect operation. After all, the light reminds you of oil changes and inspections, and ignoring it could lead to major problems. I've personally seen a friend who neglected to reset it and ended up with low oil, causing engine damage and costly repairs.
I just learned how to reset the Buick Envision maintenance light, and the steps are quite simple. First, turn off the engine and switch the key to ON without starting it. Use the steering wheel menu button to select the settings option, navigate to the maintenance reminder, and confirm the reset. If you're unsure about the button locations, refer to the diagrams in Chapter 2 of the user manual. Don't delay too long in doing this—when the light comes on, it's annoying and can lead to misjudging the maintenance status. After completing the reset, remember to take a test drive to confirm the light is off and drive with peace of mind.
