How to reset the maintenance light on the Chery Jetour X70?

[JessicaMarie]

The method to reset the maintenance light on the Chery Jetour X70 is as follows: With the vehicle turned off, press and hold the menu button on the steering wheel, then press the power switch twice without stepping on the brake pedal. Keep holding the menu button until the dashboard lights up and the maintenance light disappears. The purpose of the maintenance light is to record the mileage of important components, functioning like a timer to remind the owner and automotive maintenance personnel. Taking the 2021 Chery Jetour X70 as an example, its body structure is a 5-door, 5-seat SUV with dimensions of 4720mm in length, 1900mm in width, and 1710mm in height, a wheelbase of 2745mm, a fuel tank capacity of 55 liters, and a trunk capacity ranging from 1260 to 1680 liters.

[McClara]

Last time I took my Chery Jetour X70 for maintenance, that little light stayed on after the service, which was quite annoying. I tried resetting it myself and found out that I had to turn off the engine first, then press and hold the MODE button on the steering wheel while stepping on the brake to start the engine. After waiting for about ten seconds, the dashboard light went off, and then I turned off the ignition and restarted the car to check if the light was still on. The whole process required not letting go of the button. The first time I did it, I was a bit flustered, but luckily it worked. From now on, I’ll remember to do this after every maintenance to avoid another trip to the shop. By the way, I’d like to remind my fellow car owners that if the light doesn’t go off, it might be because the button wasn’t pressed properly or there’s another electronic issue with the car, so it’s best to check carefully to prevent bigger problems.

[SanJulianna]

I'm very familiar with the Chery Jetour X70. To reset the maintenance light, you need to use a combination of buttons. The key point is to operate when the car is completely turned off. I've done it several times. Generally, you need to hold down a certain button on the multifunction steering wheel, such as the MODE button, then start the engine and let it run for a few seconds. The system will automatically reset. Don't release the button too soon—wait until the indicator light disappears before driving normally. This design is for anti-theft purposes and accurate reset. If you're not familiar with the process, read the manual carefully or check the step-by-step video on the official app. You'll understand after trying it once. The key is to be careful and not miss any details.

[LaIvan]

Resetting the maintenance light is quite simple. After turning off the engine, hold down the steering wheel button, start the ignition, and wait for the light to go out—done. My tip: Using the MODE button is the most reliable method.