How to reset the maintenance light on the Changan Benben?
2 Answers
To reset the maintenance light on the Changan Benben, follow these steps: 1. With the engine off, press and hold the trip meter reset button located below the tachometer. 2. Turn the ignition to the ON position and release the trip meter reset button. The display will show the "SERVICE" indicator. 3. Pull out the minute button on the clock and turn it to the right. The odometer reading will appear on the display. 4. Turn the engine off to reset the reminder message. 5. Turn the ignition to the ON position again, and the "SERVICE" indicator will disappear. Regarding body dimensions, the Changan Benben measures 3730mm in length, 1650mm in width, and 1530mm in height, with a wheelbase of 2410mm.
When I used to drive the Changan Benben, I encountered the maintenance light coming on and managed to reset it myself. Here’s how: Get in the car without starting the engine, press and hold the OK button on the steering wheel, then turn the key to the ignition position (without starting the engine). Keep holding the button for about 5-7 seconds. At this point, the maintenance light on the dashboard will start flashing or a small wrench icon will appear flashing. Release the button and quickly press the OK button again to confirm. This should turn off the light. However, the procedure might vary slightly for different model years, so the safest approach is to check the maintenance manual or take a photo of your dashboard and ask owners of the same model in car owner groups. Remember, after resetting the light, make sure to perform the necessary maintenance promptly—change the engine oil and filter as needed, and don’t delay it for too long.
