How to Reset the Maintenance Light on the Atenza?
4 Answers
The method to reset the maintenance light on the Atenza is as follows: 1. With the ignition switch in the off position, press and hold the "Reset" button on the right side of the instrument panel; 2. Turn on the ignition switch without starting the vehicle; 3. Release the "Reset" button and briefly press the "Clock Adjustment" button once; 4. The maintenance cycle display will enter reset mode, and after a few seconds, it will return to the normal view; 5. After the maintenance light reset is complete, you can check the interval mileage until the next maintenance by pressing the "Clock Adjustment" button four times, and the multi-function display will show the distance until the next maintenance. The dimensions of the Atenza are 4870mm in length, 1840mm in width, 1450mm in height, with a wheelbase of 2830mm.
I've been driving the Mazda6 (Atenza) for several years, and resetting the maintenance light is actually quite simple—it mainly involves button operations on the instrument panel. Here are the specific steps: First, turn the key to the ON position without starting the engine, and you'll see the maintenance light illuminated. Then, press and hold the TRIP or ODO button near the steering wheel for about 10-15 seconds until the light turns off, indicating a successful reset. There might be slight variations for different model years; for example, the 2020 model requires holding the HOLD button for a few seconds. I recommend checking your owner's manual first, as it usually provides detailed instructions. If the light remains on after the operation, it could indicate a system fault or an unrecorded previous service, in which case a visit to the dealership is necessary. Don’t underestimate this light—it primarily reminds you to change the oil and perform regular maintenance. Ignoring it may affect your car’s performance. Personally, I’ve made it a habit to reset it after every service to prevent the light from coming on unnecessarily, keeping the car more hassle-free.
As an average car owner, I've reset the maintenance light on my Mazda Atenza a few times and found it quite straightforward. The basic process is: first, sit in the driver's seat, insert the key and turn it to the ON position without starting the engine; then locate the TRIP RESET button below the dashboard, press and hold it for about ten seconds until the wrench icon disappears. For newer models after 2021, you might need to long-press the MODE button in combination. I was initially worried about making mistakes, but it worked fine after one try. If the light doesn't reset, it could be a wiring issue or the software needing an update, in which case I recommend driving directly to a professional repair shop. On related topics, the maintenance light usually comes on to remind you it's time for an oil change, and regular maintenance can extend your car's lifespan. Also, note that it's safer to perform these operations with the car in the ON position, not while driving. Once you've ensured the steps are correct, your car will feel as good as new without disrupting daily use.
When it comes to resetting the maintenance light on the Mazda Atenza, I often hear car enthusiasts discussing it. The general method is a one-step process: first, turn the key to the ON position without starting the engine; then look at the dashboard, press and hold the ODO button for about 10 seconds until the light goes off. Different models may have slight variations, such as requiring repeated presses of the setup button. This light is actually a reminder system from the onboard computer, indicating that the preset mileage or time since the last maintenance has been exceeded. If not reset, the light will keep flashing every time you start the car, which can be annoying. The advantage of doing it yourself is saving money and time. It's recommended to perform this operation regularly along with checking the engine oil and filters. I usually reset it immediately after each maintenance to keep the records accurate.
