How to Reset the Maintenance Light on the 2020 Tiggo 8?

1 Answers
AylaLynn
07/30/25 5:44am
After starting the vehicle's power, press the button on the left side of the steering wheel to switch between different menus until the dashboard displays temperature and tire pressure. By pushing the middle OK button downward, enter the [Menu] interface. Press the left or right directional button to find the driving information menu, then click the [OK] button to enter. After locating the maintenance mileage option, press the downward button as prompted. Click the [Yes] option in the pop-up window on the screen, then click the [OK] button to reset and eliminate the maintenance light.
Was this review help?
20
2
Share
More Forum Discussions

How to Duplicate a Car Key?

If you lose your car key, you can go to a 4S store to replace a remote key. As long as the key is matched with the car's password, the 4S store will generally help you get it done. Once a new remote key is duplicated, the previously lost key will immediately become invalid. Even if someone picks up the previously lost key, it cannot be used.
10
0
Share

How to Deal with Driving Below the Minimum Speed Limit on Highways?

According to relevant laws and regulations, driving below the minimum speed limit by less than 20% will not result in a fine. However, driving below the minimum speed limit by more than 20% will incur a penalty of 3 demerit points. No penalties will be imposed if the vehicle's speed on the highway is below the minimum speed limit due to road construction, traffic congestion, or adverse weather conditions such as rain or fog.
9
0
Share

How to Deal with Whitening of Car Interior Leather?

Spray a professional wax remover cleaner on it, scrub with a cotton cloth or sponge, and wipe off the cleaning substance with a cloth. Then use a stronger cleaner. Fill the damaged surface with a repair paste and sand it with 800-grit sandpaper until the surface is smooth. Re-spray with the prepared color-changing paint. You can try a small part first to see the effect before proceeding with full-scale application.
17
4
Share

How to Remove the Plastic Flywheel Ring?

Use a soldering iron to reach inside and melt it, dividing it into two semicircular pieces or preferably three fan-shaped segments, allowing you to remove them one by one. It is recommended to disassemble the flywheel instead, as using a soldering iron may cause heat-induced stress deformation in the hub components and spokes, potentially affecting the bike.
4
2
Share

Why does the car light stay on and can't be turned off?

If the light stays on, it means the battery is discharging. The light goes off after starting the engine because the alternator is charging the battery, putting it in a charging state. If the charging warning light remains on after starting the engine, it indicates that the car's charging system is not functioning properly and there is a fault in the charging system. Alternatively, if the charging warning light comes on while driving, it means the alternator is charging the battery, and the car is running on battery power.
12
3
Share

How to Deal with Rust Spots on a Car?

You can use a clay bar to clean the car's surface while washing the car. A clay bar is a non-abrasive paint-cleaning tool that can remove stubborn stains from the car's surface. If you want to remove rust spots on white car paint, you need to apply more force and scrub back and forth several times until it's clean during the process.
13
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.