How to reset the maintenance light on the 2018 Haval H6?
3 Answers
The method to reset the maintenance light on the 2018 Haval H6 is: After turning off the ignition switch, press and hold the trip meter reset button on the combination meter. While holding the button, turn on the ignition switch. The odometer display will start counting down. When the display shows 0000.0, release the button. At this point, the wrench indicator light on the combination meter, which indicates maintenance operation, should turn off. The body dimensions of the 2018 Haval H6 are: length 4649mm, width 1852mm, height 1710mm, with a wheelbase of 2680mm. The 2018 Haval H6 is equipped with a 1.5T turbocharged engine, delivering a maximum horsepower of 150PS, a maximum power of 110kW, and a maximum torque of 210Nm, paired with a 6-speed manual transmission.
When I used to drive my 2018 Haval H6, the maintenance light kept coming on, and I reset it myself a few times. Simply put, you turn off the car key to the engine-off state, then press and hold the ODO mileage button on the dashboard. Next, turn the key to the ON position (where the dashboard lights up but the engine doesn't start) and keep holding the button for about ten seconds. The maintenance light will flash a few times and then disappear. If it doesn't work, it might be because the button wasn't held long enough or the procedure got messed up—try repeating the process. Honestly, this design is just a reminder for us to service the car on time. After driving the H6 for a few years, I know that when the light comes on, it's time to check the engine oil or filters to avoid part wear. Doing it yourself saves time and effort, but make sure to check the owner's manual to confirm the steps and avoid mistakes. If you really can't figure it out, just go to a repair shop—safety first.
I just got my hands on an 18-model H6 not long ago when the maintenance light came on, which made me a bit nervous. As a newbie, I first checked the manual. Haval's instructions were quite clear: Don't panic after turning off the engine, find the ODO button near the steering wheel and hold it down. Then turn the key to the ON position without starting the engine, keep pressing for a few seconds and the light will go off. If it doesn't work, try restarting. This light is an intelligent reminder that maintenance is due, not necessarily indicating a car problem. I think newbies shouldn't fear failure; practice makes perfect, and you can also learn some basic maintenance. Remember to ensure the car is parked safely on level ground before operating, don't rush. After resetting the light, it's best to record the mileage for easier monitoring next time.
