How to reset the maintenance light on Roewe 360?

What to Do When the Car Washer Nozzle Has Weak Water Spray?

Solutions for weak water spray from car washer nozzle: 1. Determine whether the issue is on one side or both sides. If it's on one side, it is usually caused by a clogged nozzle on that side. Solution: Use a sewing needle, pin, or very thin wire to poke the nozzle, spray out the remaining washer fluid, and then use an air gun to blow through the clogged nozzle. 2. Check the motor and its wiring. Have one person operate the washer button inside the car while another opens the engine compartment to listen for any sound from the washer motor. If there is sound, the motor may be faulty. If there is no sound, the motor itself is likely defective. Solution: First, check if the filter is clogged. A clogged filter can be repaired by removing the water hose connected to the nozzle, opening the washer fluid filler port, and using an air gun to blow through the hose. This will force the washer fluid out through the filler port and remove any debris stuck on the filter. If the motor is faulty, it must be replaced.

8

5

Share

What Materials Are Needed for Car Polishing?

Materials used for car polishing include a polishing machine, polishing pads such as wool pads, rabbit hair pads, sponge pads, etc., polishing compounds, masking film, paper tape, etc. Generally, after polishing is completed, waxing, sealing, or coating is required. The steps for car polishing are as follows: 1. Wash the entire car. Use a paint cleaner with strong decontamination power to clean the entire car. When using the cleaner, avoid causing new scratches from particle dust during the polishing process. 2. Sand with water sandpaper. For defects such as coarse particles, fine sandpaper marks, or flow marks on the paint surface, use 600#-1000# water sandpaper wrapped around a small rubber block to gently sand the surface until smooth before polishing. Be careful not to sand through the paint layer. 3. Coarse and fine grinding. Use a mechanical grinder with coarse polishing compound to grind away the marks left by the water sandpaper, then add fine polishing compound for fine polishing. 4. Polishing. Use a mechanical polisher with a mirror finish compound to remove the swirl marks left by the coarse polishing compound, achieving a mirror-like finish on the paint film. 5. Manual polishing. After grinding and polishing, wipe off the polishing compound and immediately use a cotton cloth soaked in polishing wax to wipe the polished areas. Then, use a dry cotton cloth to remove any excess wax, leaving the paint surface bright and dazzling like a mirror.

6

1

Share

What is the izda car?

Toyota does not have a car named izda. The similar name is izoa, which is called Yize in Chinese. It is a compact SUV produced by FAW Toyota. The following is an introduction to Yize: 1. The entire series is equipped with a 2.0L Dynamic-Force-Engine, which is the first TNGA honeycomb concept SUV from FAW Toyota. 2. The 2021 Yize is an annual facelift model, not a generational change. This model adds the Yize Sport Edition, featuring exclusive sports kits, 17-inch smoked black aluminum alloy cutting wheels, exclusive silver-black Branno leather seats, and a unique silver-black roof body color, creating a strong visual sense of sportiness. 3. In terms of power, the new car still uses a 2.0L naturally aspirated engine with a maximum power of 126 kW and a maximum torque of 203 Nm. 4. In terms of the transmission system, it is matched with a CVT gearbox. From the powertrain perspective, this 2.0L plus CVT combination is used in many Toyota models, such as the Toyota Avalon and Toyota Camry. In terms of chassis tuning, models built on the TNGA platform have a chassis tuning that leans towards German cars, creating a strong sense of premium and stability during driving.

5

1

Share

Where are the instrument panel lights on the Ford Focus?

Focus instrument panel lights are located on the dashboard below the steering wheel. Instrument panel lights are functional lamps used to indicate vehicle performance, and they are divided into three categories: general indicator lights, warning indicator lights, and fault indicator lights. The reasons why instrument panel lights cannot be turned off and their solutions are as follows: 1. Automatic illumination: The instrument panel lights remain on after closing the car door, which is one of the car's functions. They will turn off after locking the car; 2. Non-automatic illumination: The instrument panel lights change with the headlight switch. When the headlights are turned off, the instrument panel lights will naturally turn off; 3. Fault lights: A fault in a certain component inside the car, such as the engine, oil, braking system, water temperature, etc. These require troubleshooting and the use of a decoder to clear the fault codes before the lights will turn off; 4. Reminder lights: These remind that the car door, front hood, rear hood, etc., are not closed properly. Simply handle the relevant components according to the reminder light's prompt.

11

4

Share

When is a car considered a China IV vehicle?

China IV emission standards began in 2011 and lasted until 2018 when China V standards were implemented. Therefore, vehicles produced between 2011 and 2017 all meet China IV standards. The China IV standards require approximately 50% lower emissions of various pollutants compared to China III standards. Here are the relevant details: The China IV emission standard is the fourth phase of national motor vehicle pollutant emission standards in China. The main pollutants emitted by vehicles include HC (hydrocarbons), NOx (nitrogen oxides), CO (carbon monoxide), and PM (particulate matter). Through the application of technologies such as improved catalytic converter active layers, secondary air injection, and exhaust gas recirculation systems with cooling devices, the standards aim to control and reduce vehicle emissions to below specified levels.

7

5

Share

What to Do If the Maintenance Manual Is Lost?

Go to the 4S store and verify with the staff to confirm that the car was purchased there. In this case, the first maintenance can be done without the maintenance manual. For subsequent maintenance visits, the 4S store's computer will have the repair and maintenance records, eliminating the need for the maintenance manual. Below is relevant information about car maintenance: 1. Car maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. Modern car maintenance mainly includes the maintenance of the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, etc. 2. The purpose of car maintenance is to keep the car clean, maintain normal technical conditions, eliminate potential hazards, prevent faults, slow down the deterioration process, and extend the service life.

12

3

Share

How to reset the maintenance light on Roewe 360?

What to Do When the Car Washer Nozzle Has Weak Water Spray?

What Materials Are Needed for Car Polishing?

What is the izda car?

Where are the instrument panel lights on the Ford Focus?

When is a car considered a China IV vehicle?

What to Do If the Maintenance Manual Is Lost?

How to switch between D and S gears?

What do the plus and minus signs on an automatic transmission car mean?

What are the differences between blue license plates and green license plates?

What does it mean when the ABS light comes on in a car?