How to Reset the Maintenance Light on Mitsubishi Outlander?

1 Answers
LeGriffin
07/25/25 9:23am
Turn the key to shut off the engine. Locate the trip computer control button on the left side of the center console. Press and hold the button for more than 5 seconds, then press the ignition button to start the vehicle. The maintenance light will be reset.
Was this review help?
19
5
Share
More Forum Discussions

What to Do When the Car Starter Doesn't Respond?

If not, you can turn on the headlights to observe their brightness. If the headlights dim or do not light up at all, it indicates a severe battery discharge. Use the emergency method of short-circuiting the 30 and 50 terminals to start the car. This indicates an internal fault in the DC motor, possibly due to stuck brushes. You can tap the starter twice with a wrench.
14
0
Share

Where to Inspect the Automotive Gas Tank?

During the inspection, you need to bring the CNG conversion registration certificate, vehicle license, ID card, and the gas tank's factory qualification certificate. In some regions, the vehicle management office authorizes several specialized institutions within a certain area to conduct gas tank inspections. You can call the local vehicle management office for inquiries.
16
1
Share

How to Remove Car Stains?

Go to a 4S shop for polishing. It is recommended to use toothpaste, which contains certain abrasive components. Dip a clean car towel in an appropriate amount of toothpaste and scrub in a circular motion. Spray some water on the stain, fully moisten it, and then wipe it with a clay bar for effective results. Spray resin remover on the car paint that has been rubbed onto the body.
16
0
Share

How to Check Which Model a Car Brand Belongs To?

Click on the Mini Programs in Discover. After entering the Mini Programs, enter the VIN in the search bar, and multiple VIN information query mini programs will be displayed. Some VIN information query mini programs require selecting the brand and model. First, enter the 17-digit VIN as required by the steps. At this point, you need to take a photo and upload the vehicle identification code from the vehicle registration certificate. Finally, you can compare the vehicle configuration model with the query results displayed below.
12
2
Share

How to Deal with Wet Car Floor?

If there is water accumulation on the floor mats, remove the rubber mats and dry or clean them. Quickly wipe away any water on the floor with a cloth as soon as possible. Spray car-specific foam cleaner onto any fabric surfaces and gently wipe with a cloth. Open the car doors and windows to allow the moisture to dry completely. Check if the sunroof is leaking; prolonged exposure to sun and rain can cause aging.
8
3
Share

How to Turn on Car Lights at Night?

Before starting, turn on the lights to clearly see the road ahead. When parking, stop the car first and then turn off the lights. When driving below 30 km/h, use low beams; when exceeding 30 km/h, switch to high beams. When there is oncoming traffic, promptly switch the lights back to low beams. When driving in well-lit urban areas or sections at night, use low beams and maintain a safe speed. When temporarily parked on the roadside, turn on the parking lights, taillights, and width markers.
7
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.