How to reset the maintenance light on Mazda Atenza?
3 Answers
Mazda Atenza maintenance light reset steps are as follows: 1. First, press the Atenza's one-touch start button. 2. Then press the INFO button on the left side of the multifunction steering wheel, followed by the SET button on the right side of the steering wheel. 4. At this point, the central LCD screen will display the vehicle maintenance information. 5. Finally, press the OFF button at the lower right of the steering wheel, and the wrench icon will disappear. The Atenza maintenance light can also be reset by connecting a diagnostic computer. This method is usually used by 4S shop maintenance staff to help us reset the maintenance light.
As a Mazda owner, the maintenance light always annoys me when it comes on. Resetting it isn’t actually difficult. First, turn off the car and make sure the engine is completely shut down. Then, sit in the driver’s seat and locate the TRIP button on the dashboard—hold it down gently. At the same time, press the brake pedal (some model years may not require this, but it’s safer to do so), then turn the key or press the start button to the ON position (don’t start the engine). Keep holding the TRIP button for about 10 seconds, and you’ll see the maintenance light blink or turn off directly. Release the button and turn off the ignition. Once done, it’s a good idea to check the oil or filter condition since the light is a reminder that maintenance is due. Ignoring it could affect your car’s lifespan, especially since safety comes first when driving at high speeds. I personally do a quick check on my car every week—these small DIY tasks save me trips to the dealership and help me understand my car better.
Recently studying automotive electronics, the essence of maintenance light reset is simply a basic reset of the instrument panel system. For the Mazda Atenza (Mazda6), the operation is quite straightforward: After turning off the car, hold down the ODO or TRIP button on the instrument panel without releasing. Then turn on the ignition (without starting the engine), hold for a few seconds, and the light will disappear. Remember to release the button before shutting down. If unsuccessful, it might be a button contact issue—check for dirty connectors or wiring. Regular engine maintenance is recommended to prevent the light from frequently coming on. I often help friends with similar issues; DIY not only saves trouble but also avoids misreading fault codes. Don’t forget to update the software periodically, as Mazda models occasionally receive system upgrades.
