How to reset the maintenance light on Junma S70?

1 Answers
Catalina
07/25/25 12:28pm
S70 maintenance light reset method is as follows: 1. First, start the Junma S70 vehicle to illuminate the dashboard. 2. Observe the dashboard of the Junma S70, where you will see a maintenance wrench icon as shown in the figure below. 3. Then, press and hold the button at the top of the Junma S70's wiper for about ten seconds. 4. At this point, you will see "set8000Km" appear on the Junma S70's dashboard, indicating the next maintenance mileage. 5. Finally, after waiting for more than ten seconds, the maintenance light of the Junma S70 will be successfully reset.
Was this review help?
9
2
Share
More Forum Discussions

How to Handle the Transfer of a Used Car?

You need to prepare the original ID cards and copies of both the buyer and seller, the original invoice of the vehicle's initial purchase or the original invoice of the last transfer and its copies, among other required documents. Once all the documents are ready, you can submit the application to the relevant department and complete the procedures.
7
1
Share

How often should a 7-seater vehicle undergo annual inspection?

Non-operational small and mini passenger vehicles with 7 to 9 seats within 6 years are included in the exemption range for annual inspection. For non-operational small and mini passenger vehicles over 6 years but less than 10 years, the inspection frequency is adjusted from once per year to once every two years.
13
0
Share

How to Remove Windshield Wipers?

Lift the wiper arm naturally upward along the direction of the wiper to move it away from the vehicle body. Tilt the wiper blade backward to make it perpendicular to the wiper arm. Locate the securing clip at the connection point between the wiper blade and the wiper arm. Pull the tab outward and then spread the wiper blade open. Then pull the clip sideways to release it from the wiper blade connection.
6
0
Share

What is the free travel of a clutch?

Clutch pedal free travel refers to the gap between the inner end of the clutch diaphragm spring and the release bearing as reflected on the pedal. Specifically: From the initial depression of the clutch pedal to the point where it begins to act on the clutch to disconnect power transmission, there is a portion of the pedal travel that is load-free and performs no work - this is the clutch pedal's free travel. Reason for free travel: Since the clutch release bearing is the most vulnerable component, a clutch free travel is designed to prevent or reduce unnecessary damage to the release bearing.
2
4
Share

What is the process for reviewing a driver's license?

Bring the original ID card, original driver's license, photos, and a qualified medical examination certificate to the vehicle management office, and fill out the license renewal application form. Submit the form and documents to the staff. After verification and confirmation that there are no issues, pay the fee, and the new license will be issued on the spot for immediate collection. Before the review, check if there are any outstanding traffic violations. If there are, they must be resolved first; otherwise, the review will not be processed.
3
2
Share

Is the BMW X1 equipped with a three-cylinder engine?

The BMW X1 is equipped with a three-cylinder engine, model number B38A15C. Taking the 2021 Fashion Edition BMW X1 as an example, its body dimensions are: length 4565mm, width 1821mm, height 1620mm, wheelbase 2780mm, fuel tank capacity 61L, and trunk capacity 505L. The 2021 Fashion Edition BMW X1 features a front MacPherson independent suspension and a rear multi-link independent suspension. It is powered by a 1.5T turbocharged engine with a maximum horsepower of 140PS, maximum power of 103kW, and maximum torque of 220Nm.
1
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.