How to Reset the Maintenance Light on Great Wall Poer?
3 Answers
Turn on the ignition switch to power up the vehicle. Press the button on the instrument panel to switch the display mode to instant fuel consumption. Turn off the ignition switch. Press and hold the mode switch button on the instrument panel, turn the ignition switch to the NO position, then release the mode switch button. Press both the mode switch button and the time adjustment button on the instrument panel simultaneously to reset the maintenance light.
When I used to drive the Great Wall Pao, I often encountered the maintenance light coming on. After servicing, it's crucial to reset it promptly to avoid misleading the system. The operation is quite simple: Sit in the driver's seat, don't press the brake, insert the key and turn it to the ON position without starting the engine. Then, locate the TRIP button on the dashboard or the reset button near the steering wheel, press and hold it for about 10 to 20 seconds. You'll see the maintenance indicator light flash and then turn off. Be patient throughout the process; don't rush to manually interrupt it, or you'll have to start over. I recommend recording the reset time each time for easier prediction of the next service. If the light doesn't go off, don't tamper with the circuits randomly—it might be a minor module issue. It's best to consult the manual or have a professional shop take a look. Remember to perform this only after maintenance to avoid missing critical servicing that could lead to vehicle damage.
Resetting the maintenance reminder light is a handy little skill, and I've used it a few times with smooth results. The key steps are simple: First, turn off the engine without pressing the accelerator and sit tight. Insert the key and turn it halfway to the ACC or ON position to power up the dashboard. Then, press and hold the adjustment button until you see the indicator light change on the screen or hear a beep. The whole process takes less than 30 seconds, but avoid doing it on bumpy roads to prevent accidental triggers. I’ve noticed occasional failures due to unstable battery voltage, but resetting it right after maintenance usually solves the issue. Keeping up with regular vehicle checks makes this method both convenient and safe, saving unnecessary trips.
