How to Reset the Maintenance Light on Great Wall Fengjun 5 Diesel?

Where is the 2TZD engine produced?

2TZD engine is produced in Sichuan, and the 2TZ engine is manufactured by Mianyang Xinchen Power Machinery Co., Ltd. Mianyang Xinchen Power Machinery Co., Ltd. is controlled by Brilliance Auto Group and is a recipient of the National May Day Labor Award, a pilot enterprise for innovative construction in Sichuan Province, a demonstration enterprise for high-tech industries in Sichuan, and one of Sichuan's key "100-billion-yuan enterprises" under cultivation. Below is an extended introduction: Company Strength: The company has a production capacity of 500,000 powertrain units and an engine market presence of 1.8 million units. It possesses a nationally recognized enterprise technology center and a nationally accredited laboratory. The NVH project is included in the National High-Tech Industrial Development Project Plan, the new diesel car engine is part of the National "863" Program, it collaborates with Tianjin University on the HCCI (Homogeneous Charge Compression Ignition) technology national plan, and works with GAC Changfeng on the National "Ten Cities, Thousand Vehicles" hybrid power initiative.

6

3

Share

What is 30 psi in tire pressure?

30 psi is approximately 2.1 bar in tire pressure. According to the international GBT2978-2008 standard, the recommended tire pressures for different types of tires are as follows: Standard tires: 2.4-2.5 bar; Reinforced tires: 2.8-2.9 bar; Maximum pressure: should not exceed 3.5 bar. Tire pressure, strictly speaking, refers to the air pressure inside the tire. Normal tire pressure in winter: In winter, the tire pressure should be based on the standard tire pressure of the vehicle, with an appropriate increase of about 0.2 bar. Normal tire pressure in summer: Generally, the lower limit of the standard tire pressure for the vehicle's tires is sufficient. For example, the lower limit for standard tires is 2.4 bar. If the car is often parked outdoors, the tire pressure can generally be about 0.1 bar lower than the standard to avoid tire blowouts due to high temperatures.

19

3

Share

What is the difference between 2h4h and 4l?

The differences between 2h4h and 4l are as follows: 2h stands for two-wheel drive, which provides smaller driving force and lower driving torque, suitable for urban road driving in general vehicle models but not for off-road or complex road conditions. 4h stands for high-speed four-wheel drive, where the gear ratio in the transfer case is smaller, allowing for relatively higher speeds, but the power may not be sufficient, making it suitable for mild off-road conditions. 4l stands for low-speed four-wheel drive, where the gear ratio in the transfer case is larger, amplifying the torque while reducing speed and increasing power, making it suitable for extremely harsh road conditions. Usage scenarios: For conditions like snow, mud, and desert, it is not recommended to use 4l; instead, use 4h. The reason is that on low-traction surfaces during startup, the torque amplified by 4l can be too large, causing the tires to spin momentarily and making it difficult to start. Switching between two-wheel drive (2h) and all-wheel drive (4h) can be done while the vehicle is moving, but only within a certain speed range.

5

0

Share

How long does it take to drive 30+ kilometers?

30+ kilometers of driving time depends on the vehicle speed. Generally, urban driving speed is 30-50 km/h, taking about 30 minutes; at 15-20 km/h it would require approximately 40 minutes. Below are the maximum speed limits for motor vehicles: Roads without center lines: 30 km/h in urban areas, 40 km/h on highways. Roads with only one motor vehicle lane in the same direction: 50 km/h in urban areas, 70 km/h on highways. For urban driving: The average speed is typically around 40 km/h, considering traffic lights and congestion, urban speeds usually don't exceed this. Expressways have a maximum speed limit of 120 km/h, with actual average driving speeds typically around 100 km/h.

3

1

Share

What speed is 30 mph?

30 mph is approximately 48.25 km/h. Here is an extended introduction to it: Conversion relationship: Miles per hour (mph, full name miles-per-hour) is commonly referred to as "mph," where 1 mph = 1.609344 km/h. Using miles as the unit: Since the English name for mile is "mile," it is transliterated as "mph." Due to the late start of China's automotive industry, especially in the early days of the country's founding, foreign cars dominated the market. Many of these foreign cars used miles per hour as the unit for speed and odometer readings.

2

0

Share

What are the differences between the 320i and 320li?

320li and 320i differ in aspects such as production origin and body length. The specific differences are as follows: Different production origins: The 320li is a domestically produced vehicle, while the 320i is an imported car. Different body lengths: The 320li is 110mm longer than the 320i. Different appearances: There are also differences in decoration, with the 320li using more chrome decorative kits. Here is some related information about the 320li and 320i: The 320i showcases its ultimate handling performance with precise steering, flexible control, and stable chassis, but it has limited interior space. On urban roads, the standard wheelbase is more practical, making parking and turning more convenient.

10

2

Share

How to Reset the Maintenance Light on Great Wall Fengjun 5 Diesel?

Where is the 2TZD engine produced?

What is 30 psi in tire pressure?

What is the difference between 2h4h and 4l?

How long does it take to drive 30+ kilometers?

What speed is 30 mph?

What are the differences between the 320i and 320li?

What car is represented by two overlapping m's?

Is 280tsi the same as 1.4t?

How Many Milliliters is 250cc for a Motorcycle?

How early can the 2-year inspection exemption label be obtained?