How to reset the maintenance light on Geely Borui?
2 Answers
Methods to reset the maintenance light on Geely Borui: 1. With the engine turned off, press and hold the short-distance counter reset button below the tachometer. Turn the ignition switch to the ON position, then release the short-distance counter reset button. The "SERVICE" indicator will appear on the display. 2. Pull out the minute button on the clock and turn it to the right. The mileage will be displayed. Turn off the engine to reset the reminder. Turn the ignition switch to the ON position again, and the "SERVICE" indicator will disappear. If manual reset fails, visit a maintenance facility to reset the maintenance light using professional diagnostic equipment.
I remember when I first encountered the maintenance light on the Geely Borui last year, I spent quite some time trying to figure it out. After getting in the car, don't start the engine immediately—turn the key to the ON position, and all the dashboard lights should illuminate. Then press and hold the TRIP button, usually the small button located at the lower right corner of the dashboard. Hold it firmly without releasing for about 5 seconds, and watch as the maintenance indicator light slowly flashes until it turns off. If it doesn't work, you can check the owner's manual or search for Geely's official guide on your phone—don't mess around and risk damaging something. It's important to reset the light promptly after maintenance, otherwise it will keep reminding you the next time you start the car, which can be quite annoying. This method applies to most Borui models, and you need to be patient when doing it. The first time might feel a bit nerve-wracking, but it's actually quite simple.
