How to Reset the Maintenance Light on Dongfeng Honda Envix?
2 Answers
Dongfeng Honda Envix resetting the maintenance wrench light steps are as follows: 1. Turn the vehicle ignition switch to ON mode. 2. Repeatedly press the SEL/RESET button until the maintenance display appears on the screen. 3. Press the Enter button, then the engine oil monitor information will appear on the screen. 4. Hold down the Enter button for about 10 seconds, and the maintenance light will be reset. The wrench displayed on the car dashboard is set by the manufacturer to remind the owner to perform maintenance at the specified mileage as needed, indicating that the vehicle requires maintenance. When this light remains on for a long time, the car should be taken to a 4S shop for maintenance.
I've tinkered with resetting the maintenance light a few times before, and it didn't seem too difficult to operate. First, park the vehicle and turn off the engine, ensuring you're in a safe position. Then, locate the small TRIP button or trip reset button on the right side of the dashboard—its position might vary slightly depending on the model year, but it's usually near the steering wheel. Hold it down, then turn the key to the ON position, being careful not to start the engine. At this point, the maintenance light on the dashboard will start flashing or dimming. Keep holding the button for about 5 to 10 seconds until the light completely turns off or the mileage display changes before releasing. Finally, turn off the key and start the engine to check if the light has disappeared. If it's still on, the method might be incorrect or there could be an issue with the button—consult the manual or try a few more times. After resetting, remember to get the maintenance done promptly, such as changing the oil and oil filter, to extend the engine's lifespan and avoid bigger trouble next time the light comes on. Regularly checking these small functions during daily car use is always a good practice.
