How to reset the maintenance light on Dongfeng Fengshen AX7

1 Answers
LeIvan
07/30/25 12:37am
Method to reset the maintenance light on Fengshen AX7: 1. Turn on the ignition switch while holding down the trip meter reset button for several seconds. 2. Rotate the key to turn off the engine, wait for 10 seconds to complete the reset. Below is an introduction to the 2021 Fengshen AX7: 1. Body dimensions: Length 4645mm, width 1880mm, height 1670mm, wheelbase 2715mm, fuel tank capacity 61L. 2. Powertrain: Equipped with a 1.5L turbocharged engine delivering maximum horsepower of 150PS, with maximum power achieved at 5500rpm and peak torque available between 1800-4000rpm.
Was this review help?
8
1
Share
More Forum Discussions

Where is the accelerator pedal in an automatic transmission car?

The accelerator pedal in an automatic transmission car is located at the far right under the foot area, with the brake pedal to its left. Both pedals are controlled by the right foot. Since automatic transmission vehicles don't have clutch operation concerns, accelerator control is relatively simpler. Generally, most automatic transmission models have slightly slower throttle response compared to manual transmissions. Therefore, for vehicles with the same displacement, automatic transmission cars typically accelerate slightly faster when the accelerator is pressed. The key technique for controlling the accelerator in automatic transmission vehicles is that the larger the engine displacement, the more gradually you should press the accelerator. Additionally, automatic transmissions also have gear shifting considerations - when you feel slight hesitation during acceleration, this indicates the automatic transmission is upshifting, at which point you should appropriately ease off the accelerator.
8
1
Share

Penalty for Expired Temporary License Plate?

Penalty for expired temporary license plate: If it is only expired but not driven on the road, there will be no points deduction or fine. If the temporary license plate has expired and the vehicle is driven on the road, the penalty includes temporary seizure of the vehicle, a fine of 200 yuan, and 3 points deducted. Penalty standard for driving with an expired temporary license plate for one day: Driving with an expired temporary license plate is considered as not displaying the license plate as required by regulations, and the driver will be fined 200 yuan and have 12 points deducted. In case of an expired temporary license plate, you can choose not to drive until the official license plate is issued, or you can reapply for a temporary license plate. However, please note that a temporary license plate can only be applied for a maximum of three times. If a motor vehicle driven on the road does not display a motor vehicle license plate, the traffic management department of the public security organ shall detain the motor vehicle and notify the party to provide the corresponding license plate.
16
0
Share

Is DSG an Automatic Transmission?

DSG can shift gears both manually and automatically. DSG differs from conventional semi-automatic transmission systems; it is based on a manual transmission rather than an automatic transmission and is also a member of the AMT (Automated Manual Transmission) family. Here is more information about DSG: 1. The external form of DSG resembles that of an automatic transmission, with gear settings identical to an automatic, but its internal structure consists of a manual transmission's gear mechanism. Since there is no external clutch, DSG incorporates two internal clutches, controlled by a computer to switch between the 1, 3, 5 gear shaft and the 2, 4, 6, R gear shaft. 2. The characteristics of DSG include the ease of operation and comfort of an automatic transmission, combined with the acceleration thrill of a manual transmission, while fuel consumption is reduced to the level of a manual transmission.
17
2
Share

What Causes High Engine Coolant Temperature?

Here are the specific methods to address excessive engine coolant temperature: 1. If the temperature is too high or the temperature warning light keeps flashing, stop the vehicle to check whether the radiator coolant level is normal, and inspect the radiator, hoses, and all connections for leaks. If no abnormalities are found during visual inspection, refill the coolant as specified and continue driving. If the temperature remains high after driving a certain distance and coolant loss is detected upon stopping, this is mostly caused by sand holes or perforations in the cylinder block water jacket. Upon discovering this fault, repairs should be performed. 2. When the engine temperature is too high, you can touch the upper and lower radiator hoses to determine the fault. If there is a significant temperature difference between the two hoses, it can be concluded that the thermostat is not functioning. 3. If there is air in the cooling system, it can form an airlock, impairing coolant circulation and causing excessive engine temperature. Run the engine at high speed and gently unscrew the radiator cap until gas begins to escape. Some coolant will flow out with the gas. Repeat this process several times until all gas is released. After troubleshooting, promptly replenish the coolant. 4. If the vehicle is driven on dirt roads or muddy sections for extended periods, debris may accumulate on the radiator, which over time affects cooling efficiency and causes high coolant temperature. First use compressed air to blow out the radiator grille, then rinse it with a water hose.
8
0
Share

Does Using the Heater in a Car Consume More Fuel?

Using the heater in a car does not consume more fuel. The warm air is derived from the heat generated during engine operation: when the engine's cooling system dissipates heat from the engine, a fan directs this dissipated heat into the car's interior, creating warm air. When the heater is not in use, the fan stops, and the heat vents close, allowing the dissipated heat to be completely released into the atmosphere. The car's heater essentially recycles waste heat and does not consume additional fuel. Precautions for using the car heater: 1. When the heater is operated in recirculation mode for extended periods, the air inside the car becomes stale, especially given the limited space in a car. Therefore, it's important to periodically open the windows for ventilation when using the heater in winter. 2. When using the heater, it's best to partially open the windows to allow some air circulation. Enabling a convection mode can prevent the interior from becoming too dry and also improve the air quality inside the car.
1
2
Share

Does the Dash Cam Consume Power When Not Turned Off?

The dash cam does consume power when left on continuously, but the power consumption is minimal. In reality, when the car is parked, the dash cam enters a dormant state. It only activates to record for 5-10 seconds when it senses vibration from the vehicle, then returns to the dormant state, resulting in very little power consumption. Here is more information about dash cams: 1. Dash cams are mainly divided into two categories: portable dash cams and aftermarket in-dash DVD dash cams. 2. Generally, dash cams do not have built-in memory and rely on memory card expansion or mobile digital hard drives. For Micro-SD card or SD card expansion, capacities vary from 2G, 4G, 8G, 16G, to 32G. For mobile digital hard drives, capacities can range from 250G, 500G, to 1000G.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.