How to reset the maintenance light on Chuanqi Wild Horse T70?
3 Answers
The method to reset the maintenance light on Chuanqi Wild Horse T70 is as follows: 1. Press the one-touch start button to start the vehicle's engine; 2. Shift the gear to neutral; 3. Press the mode button on the multifunction steering wheel; 4. Press the off button on the right side; 5. Observe the dashboard to confirm the maintenance light has been reset. The Chuanqi Wild Horse T70 is a compact 5-door, 5-seat SUV with body dimensions of: length 4555mm, width 1835mm, height 1715mm, and a wheelbase of 2665mm. It is equipped with a 1.5T turbocharged engine and a 5-speed manual transmission, delivering a maximum power of 115 kW and a maximum torque of 215 Nm.
The maintenance light on my Wild Horse T70 came on last time, and I managed to reset it following the method shared by fellow car enthusiasts online. First, you need to turn the car key to the OFF position without starting the engine. Then, locate the TRIP button or mileage reset button near the dashboard and hold it down. Next, turn the key to the ON position—the dashboard will power up, but the engine won’t start. Keep holding the button for about 10 to 15 seconds until the maintenance light starts blinking and then turns off. At this point, release the button, and the reset is complete. The manual also describes similar steps, so you can refer to it if you’re unsure. Don’t skip resetting the light—it will keep reminding you about maintenance, and delaying it may cause oil degradation, affecting engine performance. Regular maintenance is key to protecting your car. I make sure to do it annually on schedule, which saves a lot on repair costs.
As a technician who frequently works with various car models, the process of resetting the maintenance light on the Wild Horse T70 is actually quite simple. First, I'll have you turn off the ignition switch to ensure the engine is stopped. Then press and hold the TRIP button or control key on the dashboard, but remember not to use too much force. Next, turn the key to the ON position without starting the engine, just until the dashboard lights up. Continue holding the button for about 10 seconds, then release it when the maintenance light flashes or goes off. This method works for most domestic vehicles, but if it doesn't succeed, it might be a circuit issue. I recommend checking the fuse or visiting a shop to use diagnostic tools for adjustment. After resetting, remember to change the engine oil every 5,000 kilometers or six months to prevent engine wear and extend the vehicle's lifespan.
