How to reset the maintenance light on Changan CS75 Plus?

How to Deal with Fog and Water Droplets in Car Headlights?

When there is a small amount of fog or water droplets in the car headlights, simply turning on the headlights will suffice. If there is a significant amount of fog or water droplets, it is necessary to disassemble and dry them. Below are the detailed steps: 1. Small amount of fog or water droplets in car headlights: When there is fog or moisture in the headlights, turning on the headlights for about 15 minutes will generate enough heat to evaporate the fog or allow it to escape through the vent rubber tube with the heat. This usually does not damage the headlight circuit or bulbs. 2. Significant amount of fog or water droplets in car headlights: This situation indicates a problem with the headlight seal, such as damage to the headlight cover or rear cover, or issues with the seal between the cover and the rear panel. In this case, carefully inspect the headlight cover, rear cover, and vent rubber tube for any damage. If no damage is found, it is recommended to separate the headlight cover from the assembly and dry it thoroughly.

14

1

Share

What Causes the Abnormal Noise When Opening and Closing Car Doors?

Car doors produce abnormal noise when opening and closing due to the following reasons: 1. Wear and tear on the door hinges. 2. Aging of the door sealing rubber strips. 3. Excessive dirt on the door limiters. 4. Poor contact in the door lock mechanism, presence of gaps, or inadequate lubrication. Additional Information: I. Function of Hinges: Supports the door while allowing it to open and close smoothly. II. Function of Door Limiters: Restricts the extent to which the door can open. III. Design Requirements for Car Doors: 1. Ensure ease of passenger entry and exit, with the maximum opening angle controlled at approximately 65° to 70°; 2. Avoid positional interference with other parts during the opening process; 3. Reliable locking when the door is closed to prevent it from opening while driving; 4. Convenient operation of door mechanisms, including smooth closing and easy window lifting; 5. Good sealing performance; 6. Large transparent area to meet lateral visibility requirements; 7. Sufficient strength and rigidity to ensure reliable door operation, reduce door vibrations, improve side impact safety, and prevent door sagging; 8. Good manufacturability and assembly process for doors.

12

3

Share

How to Deal with Yellow Spots on a White Car?

The solutions for yellow spots on a white car that cannot be wiped off like rust spots are as follows: 1. Car wax: If the yellow spots are mild, you can use the car wax that comes with the car to apply evenly on the spots, then wipe them off with a towel with a bit of force, and rinse with water. 2. 3M beauty sandpaper: Those with professional beauty skills can use 3M beauty sandpaper to sand the yellow spots, then polish them with a polishing machine and beauty polishing wax. Those without relevant experience can drive the car to a car beauty shop for the above operations to remove the yellow spots. The methods to deal with scratches on the car are as follows: 1. Hairline scratches: Hairline scratches can generally be removed by polishing or applying a grinding agent, and they usually disappear with just a gentle wipe. 2. Medium to deep scratches: Medium and deep scratches cannot be repaired by grinding. For small areas with a dent depth not exceeding 5mm, you can fill them with putty to level the surface, then proceed with repainting.

7

5

Share

Is It Advisable to Purchase a 2019 Stock Vehicle?

Stock vehicles can be purchased, but the following conditions must be met: First, the discount must be substantial enough; second, the condition of the stock vehicle must be good. Although manufacturers do not neglect stock vehicles and perform a certain degree of maintenance, it is still difficult to guarantee that internal plastic components won't deteriorate. Additionally, you can request the 4S dealership to replace the engine oil, oil filter, and other components. For vehicles stored for an extended period, you may also ask for a battery replacement. The differences between a stock vehicle and a new car are as follows: 1. After leaving the factory, various fluids, electronic components, the battery, rubber seals, and tires in a new car may suffer from moisture damage and aging if left idle for a long time without periodic inspection and maintenance. 2. Only a very few dealers perform periodic inspection and maintenance measures, which are not costly but require manpower and time. Some 4S dealerships even store vehicles in open-air lots, exposing new cars directly to sun, rain, and wind. 3. For stock vehicles stored for too long, without proper warehousing management, the aging of electronic components and rubber products often goes undetected without professional testing equipment. Many vehicles stored for too long also experience issues like oil and power shortages.

6

2

Share

Should I Go to the Vehicle Management Office or Inspection Station for Vehicle Inspection?

Vehicle inspection requires visits to both the Vehicle Management Office and the inspection station. The Vehicle Management Office primarily handles applications for motor vehicle driver's licenses, replacements, renewals, inspections, and other related services for vehicles and drivers. On the other hand, the inspection station focuses on comprehensive performance testing of motor vehicles. While the two are related, their functions are distinctly different. More relevant information is as follows: 1. For vehicles requiring on-site inspection, both the Vehicle Management Office and inspection station must be visited: After the six-year exemption period or for vehicles requiring on-site inspection, the normal procedure is to first complete the inspection at the station and then proceed to the Vehicle Management Office for stamping. However, in some areas where the inspection station and Vehicle Management Office are networked, the entire inspection process may be completed directly at the inspection station. 2. Vehicles applying for exemption from inspection must meet the following conditions: 1) Motor vehicles registered within 6 years: Non-commercial cars (including large cars) and other small and mini passenger vehicles. 2) Excluding minivans: Vehicles with 7 or more seats. 3) Vehicles not registered for over 4 years: Excluding vehicles that have not been registered for over 4 years since their manufacture date. 4) Vehicles involved in no injury-causing traffic accidents: And have no pending traffic violation records.

8

3

Share

What causes the key symbol to flash on the Sylphy display screen?

When the key light flashes on the dashboard, possible reasons include the vehicle not detecting the smart key, low battery in the key, etc. Electromagnetic shielding can also affect the signal transmission of the key. The flashing key icon on the dashboard is the anti-theft system indicator, indicating that the anti-theft system is activated. When this light is on, the car cannot be started, and repeated ignition attempts may lock the engine, also known as engine immobilization. The anti-theft indicator has armed and disarmed states, with different flashing frequencies for each state. The indicator will flash in a regular pattern, and the flashing frequency will also vary when unlocking and driving. Methods to resolve the flashing key light: Check if the key is inside the car or nearby; replace the key battery—the Sylphy key uses a CR2025 battery, which must be replaced according to the model; take the vehicle to a professional repair shop or 4S store for a detailed inspection of the key signal transmitter and receiver. Common dashboard indicators while driving: Engine malfunction light: If the engine malfunction light comes on, it indicates a fault in the engine system, and you should contact a 4S store or repair shop immediately for maintenance. Coolant temperature warning light: If this light appears, it means the vehicle's coolant temperature is too high, possibly due to insufficient coolant. You should stop and check the situation. If the temperature is too high, do not continue driving. Tire pressure indicator: If the tire pressure light comes on, it may indicate that the tire pressure is too high or too low, possibly due to a leak or over-inflation. Use a tire pressure gauge to check the current pressure. Brake system warning light: If the brake system warning light comes on, it indicates a fault in the vehicle's braking system, which could be due to mechanical failure or insufficient brake fluid. You should stop and inspect the situation. Fuel indicator: If this light comes on, it means the vehicle is low on fuel, and you should find the nearest gas station to refuel.

15

5

Share

How to reset the maintenance light on Changan CS75 Plus?

How to Deal with Fog and Water Droplets in Car Headlights?

What Causes the Abnormal Noise When Opening and Closing Car Doors?

How to Deal with Yellow Spots on a White Car?

Is It Advisable to Purchase a 2019 Stock Vehicle?

Should I Go to the Vehicle Management Office or Inspection Station for Vehicle Inspection?

What causes the key symbol to flash on the Sylphy display screen?

What does AEB mean?

What Color of Car Engine Oil Indicates It Needs to Be Changed?

What causes the Yamaha Xunying 125 to lack acceleration?

Can I directly apply for an A2 driver's license now?