How to Reset the Maintenance Light on Changan CS15?
2 Answers
There are two reset modes for the maintenance light on the Changan CS15: one is computer-based reset, and the other is manual reset. Below is an introduction to both reset methods: 1. Manual Reset: The manual method is quite simple. Turn the ignition switch to the OFF position, press and hold the DISP button for 3 seconds, then release the button. Next, turn the ignition switch to the ON position and press and hold the DISP button for 3 seconds again to reset the maintenance light. Key points for manual reset: Note that you don't need to start the engine. Insert the key and turn it forward once to reach the OFF position, then turn it forward once more to reach the ON position. 2. Computer-Based Reset: You can visit a repair shop after maintenance and have the staff use a computer to reset the maintenance light. The maintenance light serves as a reminder. When the vehicle reaches the specified mileage, the indicator will alert the owner to perform maintenance or replace certain internal parts of the car. It also facilitates mechanics in checking maintenance records, making it an important diagnostic tool for the vehicle.
I just helped a friend reset the maintenance light on the Changan CS15. The specific steps are: First, turn the key to the OFF position to shut off the engine, then press and hold the TRIP button on the right side of the dashboard without releasing it. Next, turn the key to the ON position (the position where the dashboard powers on but the engine doesn't start). Continue holding the TRIP button for about ten seconds, and watch as the wrench-shaped maintenance light starts flashing. Wait until it completely goes out before releasing the button. Finally, turn off the power and then turn it back on, and the maintenance reminder symbol will disappear. The key to this operation is to press the button at the right moment, and there's no need to press the accelerator during the entire process. If it doesn't work the first time, check if there are other function buttons near the steering wheel blocking the operation area.
