How to reset the maintenance light on BAIC Senova D50?
4 Answers
The method to reset the maintenance light on BAIC Senova D50 is as follows: First, press and hold the third button next to the maintenance light without releasing it, then turn on the ignition switch. When all dashboard lights are off, press the second button for about ten seconds and then release it. At this point, the maintenance reset option will appear. After selecting "Confirm" by pressing the second button, press the third button to reset the light. The procedure to zero the maintenance light on BAIC Senova D50 is as follows: With the car's ignition switch turned off, press the trip odometer reset button. Then, switch the ignition to the "ON" position and continue holding the button until the trip odometer displays 0000.0. Immediately release the button, and the BAIC Senova D50 maintenance light will be successfully reset to zero.
I remember when driving the BAIC Senova D50, resetting the maintenance light was quite common. Here's the method: First, turn the ignition switch to the ON position without starting the engine. Then, press and hold the TRIP or SET button on the dashboard for about 10 seconds until you see the maintenance light start flashing or turn off before releasing. This procedure works because the maintenance light operates based on a mileage timer, and resetting it manually will turn off the light. However, don't do this too often—the light is a reminder to change the oil or perform a full service, and ignoring it could lead to accelerated engine wear or increased fuel consumption. From my experience, resetting the light immediately after each service ensures the system updates correctly and avoids false alerts. If the button operation doesn’t work, it might indicate a minor electrical issue, so it's advisable to check the fuse or wiring connections to prevent deeper problems. In short, maintaining regular service habits ensures your car runs longer and more reliably.
I believe that resetting the maintenance reminder light should be handled with caution to avoid triggering other risks. The reset process for the BAIC Senova D50 usually involves manual settings: turn the key to the ACC position without starting the engine, then press and hold the ODO button on the dashboard for at least 5 seconds until the light goes off. However, I recommend performing an actual service before resetting it; otherwise, it's like tricking the system, which may lead to incorrect maintenance intervals and affect the vehicle's condition. The light itself is a safety warning—frequent resets could allow minor issues to accumulate into major repairs, such as engine wear due to neglected oil changes. It's best to have it checked at a professional shop where they use diagnostic tools for greater accuracy and peace of mind. As a long-term driver, I've found that regular maintenance can extend a car's lifespan by over a decade—spending a little on prevention is far more cost-effective than major repairs. Safety first—don't trade convenience for risk.
Resetting the maintenance light is actually not difficult. I've done it myself on a Senova D50. The steps are: Turn off the ignition, hold down the settings button on the dashboard, then turn the key to the ON position without starting the engine, hold for about 10 seconds and release the button. But remember, the light usually comes on because the mileage has reached the service interval. It's best to perform the service before resetting. This way, after the system updates, the light won't bother you. If DIY doesn't go smoothly, it might be a minor issue with the button or circuit—don't force it. The maintenance light is like a little helper, reminding us to take care of our car. Address it early for peace of mind.
