How to reset the maintenance light on an Audi S4?

1 Answers
MacAiden
07/30/25 8:33am
Audi S4's maintenance light reset method is: 1. Open the MMI system menu and click CAR to enter the vehicle system interface; 2. Rotate the knob to select 'Maintenance and Inspection', then press the knob to confirm and enter the next submenu; 3. Select 'Maintenance Cycle', press the knob to confirm and enter the next submenu; 4. Follow the prompts to reset the maintenance cycle to complete the process. The Audi S4 is a vehicle produced by FAW-Volkswagen, equipped with a 6-speed manual or 7-speed dual-clutch transmission, quattro full-time four-wheel drive system, four-link front suspension structure, leather seats with 10-way electric adjustment and lumbar support, three-spoke leather-wrapped sports steering wheel, sunlight-sensing automatic climate control, driving information display and trip computer, Sideguard head airbags, and other configurations.
Was this review help?
14
0
Share
More Forum Discussions

What is the Redline Zone of a Motorcycle?

The redline zone of a motorcycle represents its maximum RPM peak, commonly referred to as the "redline." RPM and Gear Shifting: After starting the car, when the speed reaches 20 km/h and the RPM is around 1500-2000, shift to 2nd gear. When the RPM exceeds 2000, shift to 3rd gear, which is equivalent to around 30 km/h. Shift to 4th gear when the speed reaches 50 km/h. Under given power demand conditions, the higher the efficiency of the powertrain, the lower the fuel consumption at that moment, so it's sufficient to focus on the efficiency of the powertrain. Controlling RPM: For engine break-in and maintenance, it's essential to use high-quality lubricating oil. Additionally, operations such as accelerating, starting, shifting gears, and braking should be done slowly and gently. Lastly, keep the engine RPM between 2000-3000 rpm (for gasoline engines). For automatic transmissions, it's best to keep the RPM below 3000 rpm. Excessively high RPM can cause damage to certain engine components, while too low RPM with too high a gear can lead to increased wear on the components.
19
0
Share

Will a new car that hasn't been driven 100 kilometers display the 100-kilometer fuel consumption?

Will a new car that hasn't been driven 100 kilometers display the 100-kilometer fuel consumption. Introduction to Constant Speed Fuel Consumption: Constant speed fuel consumption refers to the fuel economy indicator when a car is driving at a constant speed on good road conditions. Since constant speed driving is a basic operating condition for cars on highways, and this type of fuel consumption is easy to measure, it is widely adopted. For example, France and Germany use the constant speed fuel consumption at 90Km/h and 120Km/h as the main evaluation indicators for fuel economy. Introduction to 100-kilometer Fuel Consumption: The 100-kilometer fuel consumption indicated in the manuals of domestic cars is generally the constant speed fuel consumption. However, since cars often experience various working conditions such as acceleration, deceleration, braking, and engine idling during actual driving, the constant speed fuel consumption is often lower than the actual fuel consumption, resulting in a significant difference. This difference is even more pronounced for cars frequently used for short-distance driving in urban areas.
19
1
Share

How long after obtaining a C1 driver's license can you upgrade to a B1 license?

C1 driver's license holders who wish to upgrade to a B1 license must have held the C1 license for at least three years and must not have accumulated 12 penalty points in any of the last three consecutive scoring cycles. Additional requirements for upgrading from C1 to B1: Physical conditions must meet the following standards: Age: Between 21 and 50 years old; Height: At least 150 cm; Vision: Naked or corrected visual acuity must reach 5.0 or above on the logarithmic visual acuity chart; Hearing: Able to distinguish the direction of sound sources with each ear at a distance of 50 cm from a tuning fork; Upper limbs: Both thumbs must be intact, and each hand must have at least three other fingers intact, with normal limb and finger movement functions; Lower limbs: Both lower limbs must be intact with normal movement functions, and the length difference between them must not exceed 5 cm. Note: The B1 upgrade application can only be processed at the vehicle management office in the driver's registered residence location.
3
1
Share

What are the product models of new energy power chassis?

New energy power chassis product models include QA003, QA007, QA010, QA016, QA021, QA023, QA047, QA048, etc. Definition of chassis height: Chassis height (i.e., minimum ground clearance) is defined as the distance between the most protruding part of the chassis and the horizontal ground when the vehicle is fully loaded. Impact of chassis height: The minimum ground clearance reflects the vehicle's ability to pass over obstacles or uneven ground without collision. Generally speaking, the minimum ground clearance of family cars ranges between 110 mm and 150 mm. The smaller the chassis height (usually referring to less than 11 cm), the better the high-speed stability, but the worse the passability.
1
0
Share

Can You Drive After Drinking Sweet Fermented Rice Wine?

Driving after consuming sweet fermented rice wine is not allowed. Dangers of Drunk Driving: The stimulation from alcohol can make people excited, leading to unintentional overconsumption. When the alcohol concentration in the bloodstream reaches a certain level, a person's reaction and control abilities decline, along with their capacity to handle emergencies. For drunk drivers, the higher the blood alcohol content, the greater the likelihood of a crash. Drunk Driving Criteria: Drinking and driving refers to driving behavior where the driver's blood alcohol content is equal to or exceeds 20mg/100ml but is less than 80mg/100ml. Drunk driving refers to driving behavior where the driver's blood alcohol content is equal to or exceeds 80mg/100ml.
5
5
Share

What is the brand of motorcycles used by the National Honor Guard?

The motorcycle brand used by the National Honor Guard is the customized version of Zhejiang CFMoto CF650G. Appearance design of CF650: The appearance design is very domineering. Especially the front face, which adopts a bionic design resembling a lion's face. Body configuration of CF650: Equipped with factory-installed protective bars, it can effectively prevent damage to the rider and the motorcycle when tipping over, providing sufficient safety. In addition, the entire vehicle is equipped with mainstream LED lights, offering excellent brightness, which also enhances driving safety. Core power of CF650: It is equipped with a relatively large displacement engine. The engine features an in-line twin-cylinder design with a compression ratio of 11.3:1. The fuel supply system is paired with the mainstream Bosch electronic fuel injection, delivering outstanding power performance.
18
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.