How to Reset the Maintenance Light on a Porsche 718?

Why is the car AC blowing strong but not cold?

Reasons why the car AC blows strong but not cold: 1. Compressor aging or damage: The cooling function of the AC mainly relies on the compressor. If the compressor belt is loose, aged, or damaged, only the blower will operate, blowing natural air instead of cold air. 2. Circulation mode: Check if the AC is in recirculation mode. The outside air mode brings hot air from outside into the car. 3. Air vents: Cold air tends to sink, so check if the AC vents are set to blow upwards. 4. Refrigerant: Too much or too little refrigerant affects cooling efficiency. Excessive refrigerant reduces heat dissipation, while insufficient refrigerant hampers cooling. 5. Clogged filter: Long-term use can accumulate dust on the filter, obstructing the flow of cold air into the car. 6. Water infiltration: If the desiccant bottle in the AC system absorbs too much moisture, the refrigerant's water content may freeze in small orifices, blocking refrigerant circulation.

13

4

Share

What is the minimum ground clearance of the Tharu?

The Tharu currently has 11 models on sale, featuring 2 engine options (1.4T and 2.0T) and 1 transmission choice (dual-clutch), with a minimum ground clearance of 150mm. Additional information: 1. Ground clearance: Minimum ground clearance refers to the distance between the lowest point of the vehicle (excluding wheels) and the supporting surface when fully loaded and stationary, indicating the vehicle's ability to pass over obstacles like stones or stumps without collision. A larger minimum ground clearance enhances the vehicle's capability to navigate obstacles or uneven terrain but raises the center of gravity, reducing stability. Conversely, a smaller minimum ground clearance decreases the vehicle's ability to traverse obstacles or rough surfaces but lowers the center of gravity, improving stability. 2. Tharu introduction: The Tharu's front face design is robust and full, with a hollowed-out front grille integrated with the headlight assembly and a rugged front bumper, highlighting its tough character. For body colors, the new vehicle offers six options: Carbon Crystal Gray, Elegant White, Ink Gray, Modern Gold, Glamour Brown, and Lake Light Blue.

7

5

Share

How to Resolve the Magotan U112300 Fault?

U112300 fault is a vehicle fault value received from the total data, usually caused by a break in the communication CAN bus. It requires inserting a gateway to check the communication lines of the missing communication module, locating the breakpoint, and repairing it to restore normal operation. It is recommended to visit a 4S shop for professional computer reading and repair. Below are specific details about the Magotan: 1. Historical Background: The Volkswagen Magotan is closely related to the Passat B6, originating from the Future B6. It is the first B-class sedan to be produced and sold by FAW-Volkswagen since its establishment. According to FAW-Volkswagen, 'Ma' symbolizes confidence, decisiveness, and dynamism, while 'Teng' represents soaring, surpassing, and passion. 2. Body Dimensions: The Magotan measures 4865mm in length, 1820mm in width, and 1475mm in height, with a wheelbase of 2812mm.

9

4

Share

Can 75% Alcohol Be Sprayed Inside the Car for Disinfection?

No. When the alcohol concentration exceeds 70%, the evaporation of alcohol increases the concentration of flammable gases in the car's interior air. If there is a small spark in the air, it may cause a flash fire. Spraying alcohol solutions also increases humidity inside the car, and prolonged dampness can lead to mold growth on the interior and damage to electronic circuits. Here are some relevant points about alcohol: 1. Scope of Alcohol Disinfection: Spray disinfection carries higher risks, and it is not recommended to use alcohol sprays for large-scale surface disinfection. Instead, localized wiping with alcohol is advised. 2. Storage: For alcohol spray disinfection, a dedicated alcohol sprayer or a sealed container can be used. Store it in a cool, dark place to avoid leakage or other hazardous incidents.

12

0

Share

Are the bumpers at 4S stores all genuine?

Under normal circumstances, the bumpers replaced at 4S stores are genuine parts. Here is a detailed introduction about car bumpers: 1. Overview: A car bumper is a safety device that absorbs and mitigates external impacts, protecting the front and rear of the vehicle body. In the past, front and rear bumpers were made of steel plates pressed into channel steel, with a relatively large gap between them and the vehicle body, which was less aesthetically pleasing. 2. Composition: Generally, a plastic car bumper consists of three parts: the outer panel, buffer material, and crossbeam. The outer panel and buffer material are made of plastic, while the crossbeam is formed by cold-rolled thin plates pressed into a U-shaped channel; the outer panel and buffer material are attached to the crossbeam. 3. Function: To absorb and mitigate external impacts on the vehicle, protecting the body. It has the ability to reduce injuries to passengers when the vehicle is subjected to high-speed collisions.

2

1

Share

Is It Safe to Install Ambient Lighting in Cars?

If installed at a qualified modification shop or modified by the original manufacturer, adding ambient lighting inside the car is considered safe. Here is some information about vehicle modifications: 1. Meaning of Car Modification: Car modification refers to the alteration of the exterior styling, interior styling, and mechanical performance of a prototype vehicle produced by the manufacturer, as needed by the car owner. It mainly includes two types: body modification and powertrain modification. 2. Relevant Regulations on Car Modification: (1) Modifications involving technical parameters of the car, such as engine displacement and turbocharging, are absolutely not allowed to be done privately. Laws and regulations impose restrictions on car modifications. (2) The model and engine type of the car cannot be changed, and the body structure must not be damaged. If the engine or body of the car is replaced, the vehicle must be inspected, and a qualified motor vehicle safety technical inspection certificate must be submitted.

13

1

Share

How to Reset the Maintenance Light on a Porsche 718?

Why is the car AC blowing strong but not cold?

What is the minimum ground clearance of the Tharu?

How to Resolve the Magotan U112300 Fault?

Can 75% Alcohol Be Sprayed Inside the Car for Disinfection?

Are the bumpers at 4S stores all genuine?

Is It Safe to Install Ambient Lighting in Cars?

How much time is allocated for the 50-to-1 license plate selection?

Will the Motorcycle Test Be Canceled Due to Rain?

What does A/C mean?

How to Clean a Car Sunroof Sunshade?