How to Reset the Maintenance Light on a Great Wall VV7?
2 Answers
The method to reset the maintenance light on a Great Wall VV7 is as follows: 1. Turn on the ignition switch, press and hold the reset button with one hand, and turn off the ignition switch with the other hand; 2. Keep holding the reset button until the clock and mileage on the dashboard completely disappear, then release the button; 3. Press and hold the reset button again with one hand, then turn on the ignition switch again; 4. At this point, the maintenance reminder on the dashboard will be flashing. Continue holding the reset button without releasing it until the maintenance reminder stops flashing, then release the button; 5. Turn on the ignition switch or start the vehicle again to check if the reset was successful. The Great Wall VV7 is a mid-size SUV with a 5-door, 5-seat body structure. Its dimensions are 4760mm in length, 1931mm in width, and 1655mm in height, with a wheelbase of 2950mm.
I've been driving the VV7 for two years and I'm very familiar with the maintenance light issue. First, get in the car and turn the power to the ON position without starting the engine. Then, press the menu button on the right side of the steering wheel to find the vehicle settings option. Go into the maintenance information section where you'll see a reset reminder button. Hold the OK button for about five seconds until it prompts that the reset is successful. Make sure the handbrake is engaged during the operation. If it doesn't work, check if the steering wheel buttons are responsive. If all else fails, it's safer to visit the 4S shop to flash the ECU. When driving, it's advisable not to ignore this light as it's connected to the vehicle health monitoring system. Resetting it immediately after regular maintenance is better for the data collection of the onboard computer.
