How to reset the maintenance light on a Bora?
4 Answers
The method to reset the maintenance light on a Bora is: 1. Press and hold the right reset button on the dashboard while turning on the ignition; 2. Release the reset button when the maintenance light enters the reset mode; 3. Press the left menu button to confirm. The Bora is a compact 4-door, 5-seater sedan with body dimensions of 4663mm in length, 1815mm in width, 1462mm in height, and a wheelbase of 2688mm. The Bora is equipped with a 1.2T turbocharged engine and a 7-speed dual-clutch transmission, delivering a maximum power of 85 kW and a maximum torque of 200 Nm. It features front-wheel drive, with a front suspension using MacPherson strut independent suspension and a rear suspension using a torsion beam non-independent suspension.
The maintenance reset light procedure for the Bora is actually quite simple, and I often help friends with this. First, turn off the car and ensure the engine is completely shut down. Then locate the ODO button or Trip button on the dashboard—different models may have slightly different names, but it's usually a small button. Press and hold it without releasing. Next, turn the key to the ON position (the position that powers the car without starting the engine) and hold for a few seconds. You'll see the maintenance indicator light start flashing or turn off. At this point, release the button, and the light will reset. However, it's important to note that this should only be done after completing scheduled maintenance, as skipping it could mislead future servicing. Regular maintenance is crucial for extending the car's lifespan and maintaining performance. If multiple attempts don't work, it's best to check the user manual or visit a service center to avoid incorrect settings. Different model years of the Bora may have minor variations, so try the standard steps first.
My Bora has been running for over three years now, and every time after maintenance, the service reminder light needs to be reset. The method comes from practical experience: after turning off the engine, sit properly, press and hold the ODO button on the dashboard (usually the small button on the right). Then turn the key to the ON position, where the dashboard lights up but the engine doesn't start. At this point, the service light will blink a few times. I usually wait about 5 seconds before releasing the button, and the light goes off. Make sure the key is in the correct position during the process, avoiding turning it to the start position. Remember to perform this operation right after maintenance to avoid accidental triggering during daily use. Car maintenance is a big deal, and timely servicing can prevent engine failures. If it doesn't work the first time, don't worry—just try again or check the manual to confirm the button's location. I do this every time, and it's quite reliable.
Resetting the Bora maintenance light is super easy! As someone who works on cars a lot, here's my routine: After turning off the engine, press and hold the ODO button on the instrument panel. Turn the key to the ON position without starting the engine. Wait until the light flashes, then release the button. Done! This reminder is for your regular maintenance—don't ignore it when it lights up. Also, make sure you press the right button and follow the steps smoothly. Daily maintenance is crucial to avoid costly major repairs.
