How to Reset the Maintenance Light on a 2020 IVECO Model?
4 Answers
First, press the left button repeatedly until the bottom line of the instrument panel displays a negative number. Then, hold down the right button until the negative number changes to 5000. After returning, the maintenance light will be reset. Many vehicles come with a maintenance reminder function, which is very practical for drivers who tend to be forgetful. Regular maintenance is crucial for vehicles, primarily involving the replacement of wear-prone parts and fluids. Below is an introduction to IVECO: 1. Nanjing IVECO is a top-tier commercial vehicle enterprise in China, featuring the IVECO product platform and the Warm 360 service platform. Its product line spans buses, off-road vehicles, chassis, and special-purpose vehicles, with over 860 diverse models. 2. Nanjing IVECO comprises four manufacturing units: the vehicle plant, SOFIM engine plant, transmission and axle plant, and F1 engine plant, which produce IVECO vehicles, engines, axles, and transmissions, respectively.
I've been driving trucks for decades and know the IVECO maintenance light reset like the back of my hand. For 2020 IVECO models, it's usually done with button combinations - turn the key to ON position without starting the engine, look for the setup button or similar mode key on the dashboard (mostly near the steering wheel), then press and hold for about 5-6 seconds until the maintenance light goes off. Remember, this light indicates required maintenance like oil changes or air filter replacement - after resetting, you must service the vehicle promptly. Forcing a reset without maintenance is cheating the system and may cause bigger problems. I once reset without servicing and ended up with a noisy engine that cost me a fortune to repair - learned that lesson the hard way. Make it a habit to only reset after completing maintenance, and pay extra attention to other dashboard warning signals as the vehicle ages.
I easily handle such things with an OBD scanner. Resetting the maintenance light on a 2020 IVECO is not complicated. Just plug a Bluetooth OBD device into the port under the steering wheel, connect to a mobile app, select the maintenance reset function, and solve it with one click. If you don't have the device, use the manual button method: turn the key to ON, locate the TRIP button on the dashboard, press and hold for three to four seconds, and the light will go out, indicating success. Remember to perform this operation only after the maintenance is completed; otherwise, ignoring the vehicle health alerts may lead to excessive wear of parts. During regular driving, I check the light status to avoid affecting the safety of long-distance trips. With rapid technological updates, the app can also diagnose other fault codes, which is quite convenient.
Before resetting the maintenance light, ensure the service is completed. For the Iveco 2020 model, the common method is to turn the key to the ON position, then press and hold the RESET or MODE button near the steering wheel for about five seconds until the light goes off. The light serves as a reminder for oil changes and other maintenance tasks. After resetting, make sure all service items are properly addressed. Forcing a reset without servicing may lead to oil leaks or engine failures. Prioritize safe driving and consult the owner's manual for button locations.
