How to reset the maintenance light of Soueast DX3?

Where is the Equinox's spare tire located?

Equinox's spare tire is located under the trunk floor panel. Open the trunk, lift the trunk floor panel, remove the foam tool kit from the rear seat, unscrew the locking knob of the spare tire, and then you can take out the spare tire. Vehicle spare tires are divided into full-size spare tires and non-full-size spare tires. More information about the Equinox is as follows: 1. The front suspension of the Equinox is a MacPherson independent suspension, and the rear suspension is a multi-link independent suspension. 2. It is equipped with a 1.5L turbocharged engine, with a maximum horsepower of 169ps, a maximum power of 124kw, a maximum torque of 250nm, and is paired with a 6-speed automatic manual transmission. Its body dimensions are: length 4646mm, width 1843mm, height 1684mm, and the wheelbase is 2725mm.

5

Share

What engine does the Lynk & Co 02 use?

The Lynk & Co 02 is equipped with a high-power version of a three-cylinder engine. Among its eight models, there are three different power output versions. Here are the relevant details: 1. The entry-level two pure lite versions use a low-power version of a 1.5T three-cylinder turbocharged engine. 2. The top two 2.0T models feature the same 2.0T turbocharged engine used in the Lynk & Co 01, with the four-wheel-drive Jin Pro version also including an all-wheel-drive system. 3. The remaining models all use a high-power version of the 1.5T three-cylinder turbocharged engine. The main promoted models of the Lynk & Co 02 are likely the four mid-range models equipped with the high-power 1.5T three-cylinder engine.

19

5

Share

What is the wheel size of the Lamando?

The tire size for the base model of the Lamando is 205/60/R16, while the high-end model comes with 225/50/R17 tires. Below is relevant information about tires: 1. The international standard tire code represents the section height and aspect ratio as a percentage in millimeters. It is followed by: tire type code, rim diameter (in inches), load index (permissible load capacity code), and permissible speed code. For example, in 175/70R1477H, 175 indicates the tire width is 175mm, 70 means the tire's aspect ratio is 70%, i.e., the section height is 70% of the width, R denotes radial tires, the rim diameter is 14 inches, the load index is 77, and the permissible speed is H-rated. 2. The tire size is printed on the sidewall and can be represented in two ways, such as 34*7 or 7.50-20. The former indicates high-pressure tires, while the latter denotes low-pressure tires. There are also many other markings, such as D for light vehicles, F for medium vehicles, G for standard vehicles, and H, L, J for large luxury and high-performance vehicles. If an R is added to the sidewall, like in 175R13, it means the tire is a radial tire, with a width of 175mm (6.9 inches), mounted on a 13-inch (330mm) diameter rim, and usually also marked with the word RADIAL.

2

1

Share

Automatic Transmission Gear Shifting Tips?

Here are the gear shifting tips for automatic transmission vehicles: 1. When unable to engage a gear or hearing gear noise, do not force it to avoid affecting shift timing and damaging components. 2. After completing a shift, do not leave your left foot idle on the clutch pedal, as this can cause clutch semi-engagement and increase mechanical wear. 3. When shifting gears while driving, except for special circumstances, do not skip gears when upshifting, but it's acceptable when downshifting. 4. When needing to engage reverse gear while driving, you must wait until the vehicle comes to a complete stop before shifting to avoid damaging components. 5. Make gear shifts clean and decisive, avoiding sloppy movements. Press the clutch pedal quickly and release it slowly.

15

1

Share

Meaning of Letters on Automatic Transmission Cars

Introduction to the letters on automatic transmission cars is as follows: 1. There are six positions for the gears of an automatic transmission car, from top to bottom: P, R, N, D, S, L. 2. P: Parking gear, starting gear. Prevents the car from rolling. 3. R: Reverse gear. Used when reversing the car. 4. N: Neutral gear. Used for temporary parking. 5. D: Drive gear. The transmission automatically shifts between gears 1-5 based on speed and throttle conditions. 6. S: Sport mode. When this gear is engaged, the gears can be freely switched, but it increases fuel consumption. 7. L: Low gear. The transmission stays in gear 1 without shifting up, providing some braking function when going downhill, and can be used in situations like slopes.

16

1

Share

What transmission is used in the BMW 3 Series?

BMW 3 Series uses transmissions from ZF. Specific performance is as follows: 1. In normal driving mode, it actively upshifts to keep the RPM below 2000, with very smooth shifting. 2. In sport mode, the transmission responds extremely quickly, with all upshifts and downshifts synchronized with your operations. Transmission technology features: 1. The latest BMW 3 Series is equipped with the third-generation ZF8HP, which has a history of eighteen years. 2. The first two generations of 8HP were optimized mainly by expanding the gear ratio, but for the third generation, maintaining 8 gears while expanding the ratio to 10 was not significant, so it still maintains an 8.6 gear ratio.

15

5

Share

How to reset the maintenance light of Soueast DX3?

Where is the Equinox's spare tire located?

What engine does the Lynk & Co 02 use?

What is the wheel size of the Lamando?

Automatic Transmission Gear Shifting Tips?

Meaning of Letters on Automatic Transmission Cars

What transmission is used in the BMW 3 Series?

How long does it take to find out about a car violation?

What is the battery model for the Borui car key?

How to Replace the Battery in a Tiida Key Fob?

How long does it take to change tires?