How to Reset the Camry Maintenance Reminder?

1 Answers
DiNevaeh
07/30/25 3:29am
Here are the steps to reset the Camry maintenance reminder: 1. Click the [Vehicle Settings] icon on the multimedia controller home screen to enter the vehicle settings interface. 2. Click Maintenance: Set the on/off for maintenance reminders and the number of months or mileage for the maintenance cycle, then click the reset button to restore the default cycle values. Here is some related information: 1. Car maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. 2. Car maintenance mainly includes the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, etc. The purpose of car maintenance is to keep the car clean, maintain normal technical conditions, eliminate hidden dangers, prevent failures, slow down the deterioration process, and extend the service life.
Was this review help?
2
3
Share
More Forum Discussions

Can You Shift from Third Gear to First Gear in Subject Three?

Subject Three does not allow shifting from third gear to first gear. Here are the specific details: 1. Reason: Shifting from third gear to first gear usually causes the engine to stall because the speed does not match. First gear is too slow and is generally only used for starting or stopping. You can skip gears when downshifting from fourth gear to second gear. When upshifting, you should shift gradually, but you can skip gears when downshifting. 2. U-turn Technique: Before making a U-turn, turn on the left signal, slow down (to about five kilometers per hour) or even stop, observe the road conditions carefully, and pay close attention to oncoming traffic (especially vehicles that are farther away but moving fast). If necessary, stop and wait. 3. Subject Three Test Content: Preparation before starting, light simulation test, starting, driving straight, gear shifting operation, changing lanes, pulling over, going straight through intersections, turning left at intersections, turning right at intersections, passing through pedestrian crossings, passing through school zones, passing through bus stops, meeting vehicles, overtaking, making U-turns, and driving at night.
2
1
Share

How to turn on the air conditioning in a Volkswagen Polo?

The new Polo has replaced the traditional rotary knobs for air conditioning modes with button selections, allowing for more convenient and precise operation while driving. Simply turn on the AUTO mode, or activate the AC, and adjust the fan speed accordingly. The correct methods for using the air conditioning in the new Volkswagen Polo are as follows: 1. Proper defogging: During rainy or snowy weather, due to high humidity inside the vehicle and the temperature difference between the inside and outside (cold outside and warm inside), fog tends to form on the inner surface of the car windows, significantly affecting driving safety. Knowing how to correctly defog the windows to eliminate safety hazards is an essential skill every car owner should master. 2. Proper use of internal and external circulation: The airflow ducts inside and outside the vehicle are interconnected. Whether the air conditioning system is on or not, air continuously flows in and out. Turning on the fan will accelerate the air exchange rate. When driving in mountainous areas or along the coast, using the external circulation mode can often fill the car with fresh air, improving the air quality inside. However, in heavy traffic areas, using the external circulation mode may draw in exhaust fumes and dust from other vehicles.
13
5
Share

Is there a time limit for pulling over in Subject 3 of the driving test?

There is no time limit for pulling over in Subject 3 of the driving test, but there is a distance limit. The scoring criteria are as follows: crossing the line results in a 100-point deduction, being more than 50 cm away from the yellow line results in a 100-point deduction, being between 30 cm and 50 cm away from the yellow line results in a 10-point deduction, and being less than 30 cm away from the yellow line results in a full score. Key points to note for Subject 3 of the driving test: Follow instructions during the test. Subject 3 covers up to 16 assessment items from the start of the test to the end. During the test, follow the voice prompts to perform the required actions. Roadside signs are only for reference; wait for the voice announcement before taking action. Stay relaxed and look ahead; avoid being too nervous. Pay attention to road markings and reference points. Ensure the gear matches the speed. Time limits for pulling over in daily driving are as follows: White line parking spaces: Parking is allowed for an extended period. Yellow line parking spaces: Do not stay for more than 5 minutes. Yellow dashed lines on the roadside: Parking is allowed for up to about 10 minutes. Yellow solid lines on the roadside: Parking is prohibited.
17
2
Share

Can I bring a bag into the car during the Subject 3 driving test?

You can bring a bag into the car during the Subject 3 driving test. Here are the details: 1. Introduction: Subject 3, also known as the Road Safety Driving Test, is part of the motor vehicle driver's license assessment. It is the abbreviation for the road driving skills and safe civilized driving knowledge test in the motor vehicle driver's examination. 2. Difficulties in the Subject 3 test: Mismatch between speed and gear: Errors related to high gear at low speed or low gear at high speed need to be avoided during the test. Before shifting gears, ensure the speed is adjusted to match the gear, then switch gears. During driving, glance at the speedometer every eight seconds to prevent such errors. Straight-line driving deviation: Many candidates deliberately slow down due to concerns about not driving in a straight line, which is not advisable. This can actually increase the likelihood of the vehicle deviating from its path, so maintaining a reasonable and steady speed is recommended. Incorrect parking by the roadside: The Subject 3 test explicitly requires that the distance from the roadside when parking should not exceed 30cm. However, this distance is hard to judge for many candidates, leading to parking too far from the roadside.
9
4
Share

How many points are deducted for rolling back in Subject 3?

Rolling back in Subject 3 deducts 10 points. Here are the specific details: 1. Deduction rules: Failing to walk around the vehicle before getting in or turning in the wrong direction, or not waiting for the examiner to confirm identity, starting the vehicle without turning it on before performing simulated lighting operations, or performing simulated lighting operations with omissions, excess actions, exceeding 5 seconds, or not turning on the lights as instructed, all these situations result in failure; not turning on the turn signal when starting, not fastening the seatbelt, not releasing the handbrake, rolling back more than 30CM after starting all result in failure, rolling back less than 30CM or turning on the turn signal for less than 5 seconds deducts 10 points. 2. Subject 3 test content: For large buses, tractors, city buses, medium buses, large trucks, small cars, small automatic transmission cars, low-speed trucks, and small automatic transmission cars for the disabled, the test includes preparation before getting in the vehicle, simulated nighttime lighting test, starting, driving in a straight line, shifting gears, changing lanes, parking by the side of the road, driving straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school zones, passing bus stops, meeting vehicles, overtaking, making U-turns, nighttime driving; test contents for other permitted vehicle types are determined by the provincial traffic management department of the public security authority.
6
5
Share

Is Carbon Cleaner Harmful to the Engine?

Carbon cleaner is not harmful to the engine. It is mainly used on various engine components and can clean amorphous and graphite-like carbon deposits inside the engine, as well as on various catalysts. Introduction to carbon cleaner: 1. Carbon cleaner is used for degreasing and cleaning automotive parts, maintaining the original brightness of metal materials after cleaning. 2. Carbon cleaner is a neutral cleaning agent that can quickly remove oil stains from metal surfaces. 3. Carbon cleaner has a strong ability to remove engine carbon deposits and can replace gasoline, kerosene, and organic solvents.
13
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.