How to replace the wiper of the Mazda 3 Axela?
3 Answers
The method to replace the wiper of the Mazda 3 Axela is: 1. Push the wiper lever to the off position, lift the wiper, and pry it up with a key; 2. Then pull the wiper and the wiper arm into a vertical position. There is a fixed groove at the head of the wiper blade. Pull it down hard or pry it with a key, and the entire rubber strip can be pulled out. The wiper is a tool on the front glass of motor vehicles to prevent rain and other dirt from affecting vision for simple cleaning. The length, width, and height of the Mazda 3 Axela are 4662mm, 1797mm, and 1445mm respectively, with a wheelbase of 2726mm, and it is equipped with a 6-speed manual transmission.
The first time I changed the wipers on my Mazda3 (Axela), I was worried about making a mistake, but the steps turned out to be super simple. First, park the car in a safe place and turn off the engine before starting. Locate the wiper arm, gently lift it to prevent scratching the windshield. Each wiper has a metal clip—just press the button or give it a twist to remove the old wiper. Then, select new wipers that match the Mazda3 model, typically 26 inches for the driver’s side and 16 inches for the passenger side. Align and insert the new wiper until you hear a click to ensure it’s securely fixed. After installation, spray some water to test if the wipers clean properly. The whole process takes just a few minutes, requires no tools, and is easy enough for beginners—plus, it saves on repair costs. Remember to clean any glass debris promptly after replacement to avoid noise.
I've been driving the Mazda3 Axela for several years, and changing wiper blades is a routine task. The key is to check that the clips are intact before removing the old ones, and ensure the new wiper is aligned correctly during installation to avoid streaks that could impair visibility. It's advisable to inspect the wiper blades every six months for cracks or wear and replace them promptly to maintain clear vision in the rain. Always purchase the correct model online and avoid cheap, low-quality alternatives. The steps involve activating the wipers to the mid-position, turning off the ignition, disconnecting the power, swiftly replacing the blades, and testing the washer fluid spray for smooth operation. Safety first—never attempt this while driving.
