How to replace the wiper of Changan Honor?
3 Answers
The method to replace the wiper of Changan Honor is: 1. Lift up the wiper arm; 2. Rotate the wiper and the wiper arm to form a 45-degree angle; 4. Observe and locate the small hidden buckle at the angle between the wiper and the arm; 5. Press the small hidden buckle and hold it, while using the other hand to pull the entire wiper downward towards the root of the arm. For wipers without a hidden buckle, simply shake and pull the wiper downward; 6. Once the hook is exposed during the downward movement of the wiper, remove the wiper from one side to complete the process. The length, width, and height dimensions of the Changan Honor are 4360mm, 1685mm, and 1820mm respectively. The vehicle offers two options for the rear suspension: four-leaf alloy steel spring suspension and spiral spring suspension, with EPS (Electric Power Steering) as standard across all models.
Last time I replaced the wiper blades on my Changan Honor, the first step was measuring the correct size, which is usually marked on the old blades or can be found in the user manual. Don't rush to buy new ones to avoid getting the wrong size. After parking and turning off the engine, gently lift the wiper arm—it's spring-loaded, so don't use too much force to prevent damaging the glass or leaving scratches. Locate the clip part, usually a U-shaped hook, and press it to remove the old wiper blade. When installing the new one, align it with the hook and snap it into place—it's quite simple. During testing, spray some windshield washer fluid to check for any skipping or unusual noises, ensuring even and clean wiping. Not replacing aged wiper blades can impair visibility, especially in rain or snow, which is particularly dangerous. I make it a habit to check the rubber strips for wear every six months and replace them promptly to avoid trouble. Buying aftermarket brands online works fine and saves dozens of yuan. With a bit of practice, it becomes easy, and beginners shouldn't be afraid of making mistakes.
When replacing the windshield wipers on a Changan Honor, prioritize safety. Before each operation, park on level ground, turn off the engine, and engage the handbrake to prevent sliding. In rainy weather, perform the task indoors to keep things dry. Then, gently lift the wiper arm—no sudden jerks—to avoid it snapping back and damaging the windshield or your hand. Check the clip type of the old wiper blades; the Honor typically uses standard U-hooks. Press to unlock and slide out the old blade. Align the new blade with the hook, press firmly until you hear a click, ensuring it’s not too loose. After installation, test by spraying water and wiping a few times to confirm full coverage without streaks or skipping. Safety reminders: Never operate on a moving vehicle. Replace worn rubber strips promptly to maintain clear visibility. For routine maintenance, keep the windshield clean and apply protective fluid to extend wiper life. The whole process takes about 15 minutes—safety first to prevent minor accidents.
