How to Replace the Wiper Blades on a Toyota Camry?
2 Answers
To remove the original wiper blades, first, lift the wiper arm. Press the tab underneath and slide out the wiper blade. Remove the original wiper blade from one side, but be very careful not to let the wiper arm snap back and damage the windshield. Slightly lift the front end of the middle tab to make installation easier. After inserting the middle tab, pull it tight until you hear a click, indicating it is properly seated. Use the same method to install the wiper blade on the other side. Once you hear the click, the installation is complete, and the wipers are ready to use.
As a long-time Camry owner, I've changed my wiper blades over ten times, and it's always been quite straightforward. First, confirm the wiper size - for Camry, the front wipers are typically 26 inches on the driver's side and 16 inches on the passenger side. Make sure to buy new ones that match these specifications, which I usually get either online or at auto parts stores. When replacing, open the hood and place some protective cloth to prevent scratching the paint. Then gently lift the wiper arm to a vertical position, press the release button or clip to remove the old blade. To install the new one, just align and push it into the connector until you hear a 'click' to confirm it's properly seated. Finally, gently lower the wiper arm back - never force it as this could damage the motor. Test the washer fluid spray to ensure smooth operation without strange noises. Replace wipers promptly when they don't clean well to maintain visibility during rain; I recommend checking them every six months for safety. Choosing blades with good rubber quality lasts longer - don't go for cheap ones that'll need replacing sooner.
