How to Replace the Wiper Blades on a Nissan Tiida?
4 Answers
Here are the steps to replace the wiper blades on a Nissan Tiida: 1. Press the start button twice to power on the vehicle and then turn it off, or start the engine and then turn it off. 2. Within 30 seconds after turning it off, pull up the wiper control lever and hold it for one second. 3. The wipers will enter maintenance mode. 4. At this point, you can replace the old wiper blades with new ones. Relevant information about wiper blades is as follows: 1. They can remove rain, snow, and dust from the windshield that obstruct the view, so they play a crucial role in driving safety during rainy weather. 2. Generally, the lifespan of wiper blades is about one year, but the specific replacement time depends on their working condition. 3. If the windshield is usually dirty, you can clean it with a cloth first before activating the wipers, which can extend their lifespan. Avoid dry wiping without using windshield washer fluid, as it can cause abnormal wear to the wiper rubber and damage to the wiper motor.
Last time I replaced the wiper blades on my Tiida myself, it took less than ten minutes. First, make sure the vehicle is turned off and lift the wipers up to avoid accidentally breaking the windshield. Press the release button at the wiper arm connection point and gently pull to remove the old wiper blade—if it's stuck, don’t force it; just spray a bit of lubricant. Prepare the new wiper blades, ensuring the size is accurate—the front wipers for a Tiida are usually around 18 inches. Universal models with U-hooks are widely available; just insert them until you hear a click. Finally, lower the wiper arms and test them with the washer fluid to ensure there’s no unusual noise or skipping. Make it a habit to check the rubber strips every six months—replace them immediately if they don’t clean well or are severely worn. This saves money and improves driving safety, especially in rainy conditions when clear visibility is crucial.
Replacing the Tiida wiper blades is quite simple, just be careful. First, turn off the engine and power, and place a soft cloth on the windshield to prevent the wiper arm from suddenly falling and damaging the glass. Then lift the wiper arm and find a support point to secure it. For removing the old blades: check the connector type—for U-hook types, simply press the clip to release. When installing new blades, align the interface and push to lock, avoiding excessive force to prevent damage. Don’t forget to test: start the engine, spray water, and swipe a few times—if it’s smooth, it’s good. Rubber blade aging is common in spring and autumn; replacing them in advance can prevent accidents caused by blurred vision. When choosing wiper blades, don’t go for the cheapest—just ensure compatibility with the size, as expensive ones aren’t necessarily more durable. Doing it yourself saves repair costs and helps you understand your car’s condition better.
Veteran driver shares wiper replacement tips. Check if the wiper rubber is cracked or noisy, replace if necessary. The Tiida's wiper arm design is reasonable, no tools needed - lift it after turning off the engine. Removing old blades: press the buckle to easily detach. When installing new ones, ensure correct orientation, align and secure the connection. Test properly before stopping, don't rush to avoid motor damage. Replace at least annually, otherwise dangerous in rainy conditions.
